Tripp Lite SMART3000SLT Plug the UPS into an outlet on a Dedicated circuit, Turn the UPS on

Page 3

	Quick Installation
	1 Plug the UPS into an outlet on a
	dedicated circuit.*
	NOTE! after you plug the UPS into a live AC outlet,
	the UPS (in “Standby” mode) will automatically
	charge its batteries,** but will not supply power to
	its outlets until it is turned ON (see Step 3 below).
	* Includes an additional plug which can be switched by a qualified
	electrician. ** The BATTERY CHARGE LED will be the only LED	1
	illuminated.	1
	illuminated.

2 Plug your equipment into the UPS.*
* Your UPS is designed to support only electronic equipment. You will
overload the UPS if the total VA ratings for all the equipment you con-
nect exceeds the UPS's Output Capacity. To find your equipment's VA
ratings, look on their nameplates. If the equipment is listed in amps,
multiply the number of amps by 120 to determine VA. (Example: 1 amp
× 120 = 120 VA). If you are unsure if you have overloaded the UPS's out-
lets, see “OUTPUT LOAD LEVEL” LED description.
3 Turn the UPS ON.	2
3 Turn the UPS ON.

Press and hold the “ON/OFF/STANDBY” button for one second. The alarm will beep once briefly after one second has passed. Release the button.

3

3

Image 3

Contents Intelligent, Line-Interactive UPS Systems SmartPro SLTUPS Connection Warnings Important Safety InstructionsBattery Warnings UPS Location WarningsPlug the UPS into an outlet on a Dedicated circuit Plug your equipment into the UPSTurn the UPS on USB and RS-232 Serial Communications Buttons Front Panel Indicator Lights Front Panel Other UPS Features Rear Panel Basic Operation Storage ServiceReassemble UPS Carefully pull the front panel away from the UPSRemove old batteries Connect new batteriesInteligentes e interactivos con la línea Manual del propietarioAdvertencias sobre la conexión de equipos Instrucciones de seguridad importantesAdvertencias sobre la ubicación del UPS Advertencias sobre la conexión del UPSConecte el UPS en una salida de un circuito dedicado Conecte sus equipos en el UPSEncienda el UPS Conexión de puerto EPO Comunicaciones USB y serie RS-232Botón ON/OFF/STANDBY Encendido/Apagado/Reserva Botones Panel frontalLuces indicadoras Panel frontal Operación básica continúaOtras funciones del UPS Panel posterior Operación básica continúa Almacenamiento ServicioConecte las nuevas baterías Quite las baterías viejasManuel du propriétaire Mises en garde Connexion déquipement Mises en garde Emplacement de lUPSDirectives de sécurité importantes Mises en garde Connexions de lUPSBrancher lUPS dans une prise dun Circuit dédié Connecter votre équipement à lUPSMettre lUPS sous tension Connexion au port EPO Ports de communication de série USB Et RS-232Boutons Panneau avant Voyants indicateurs Panneau avant Fonctionnement de base, suiteAutres caractéristiques de lUPS panneau arrière Fonctionnement de base, suite Entreposage ServiceEnlever les anciennes piles Connecter de nouvelles pilesRéassemblez lUPS Page 200607046