Q-Logic 8200 SERIES manual Directly Connecting Devices to SANbox SSP, Yellow zone Pink zone

Q

4 – Using the SANbox SSP Directly Connecting Devices to SANbox SSP

Note the following about Figure 4-2:

Primary Fabric (FC Switch A)	Secondary Fabric (FC Switch B)
Zone front_A: Primary Initiators	Zone front_B: Secondary Initiators
(yellow zone)	(pink zone)
All primary HBA ports for each host	All secondary HBA ports for each host
SANbox SSP 1, Ports 1-4	SANbox SSP 2, Ports 1-4
Zone back_A: Primary Storage	Zone back_B: Secondary Storage
(green zone)	(orange zone)
All Primary storage ports	All Secondary storage ports
SANbox SSP 1, Ports 5-6	SANbox SSP 1, Ports 7-8
SANbox SSP 2, Ports 5-6	SANbox SSP 2, Ports 7-8
StoreAge SVM Appliances, primary ports	StoreAge SVM Appliances, secondary
	ports

4.3

Directly Connecting Devices to SANbox SSP

SANbox SSP supports the direct connection of its ports to initiator devices. When directly connecting a device to an SANbox SSP port, make sure that:

■The device is explicitly configured for loop-only operation (point-to-point is not supported for directly connecting at this time). See the documentation for your device for more information.

■if you are attaching a host, the SANbox SSP port mode is set to target or initiator-target mode. Do not directly connect storage devices or the SVM appliance to the SANbox SSP.

See "Modify Port Command" on page B-14for details on configuring port modes.

SN0054628-00 A 4-5