Q-Logic 8200 SERIES manual Command Line Interface CLI Overview, Command Quick Reference by Object

Appendix B

Command Reference

Using the SANbox SSP command line interface (CLI), you can configure and manage SANbox SSP with common command sets.

This appendix provides a reference for each command in the command line interface for the SANbox SSP. The commands provide the same functions as the SANbox SSP Management GUI.

You can access the CLI through either the Local Administrative Console or a telnet session. This appendix provides the steps for accessing the CLI and describes each of the commands.

This appendix covers the following topics:

■Command Line Interface (CLI) Overview

■Accessing the CLI

■Commands

B.1

Command Line Interface (CLI) Overview

The SANbox SSP provides a command line user interface through serial, telnet, and ssh connections. All configuration, maintenance, and monitoring of the SANbox SSP are accessible through the command line interface.

B.1.1

Command Quick Reference by Object

Table B-1shows which commands are available for the major object types.

Table B-1. Commands by Object Type

Object Type	Command	Page
eths	Disable Eth Command	page B-9
	Enable Eth Command	page B-10
	Modify Eth Command	page B-13
	Show Eth Command	page B-21
	Show Eths Command	page B-22
ports	Disable Port Command	page B-9
	Enable Port Command	page B-11
	Modify Port Command	page B-14
	Modify Ports Command	page B-15
	Reset Port Command	page B-17

SN0054628-00 A B-1