Pelco manual Mounting the FT82011/FR82011 Module Using the Wall Clip

Page 15

Mounting the FT82011/FR82011 Module Using the Wall Clip

NOTE: Before mounting the FT82011/FR82011 module to a wall, ensure that there is adequate space at both ends for viewing the front-panel LEDs and for making the various rear-panel cable connections.

To attach the FT82011/FR82011 module to a wall using the supplied wall clip, refer to Figure 5 and do the following:

1.Using the two vertical or horizontal wall-mounting holes, attach the wall clip to a wall using two screws (not provided).

2.Slide the module into the clip until the two holes on the bottom of the module align with the two holes on the lower flange of the clip.

3.Attach the module to the clip using the two Phillips pan head screws provided for the clip.

UPPER

FLANGE

VERTICAL

MOUNTING HOLE (2)

HORIZONTAL

MOUNTING HOLE (2)

SCREW, PHILLIPS	LOWER
SCREW, PHILLIPS	FLANGE
PAN HEAD WITH	WALL CLIP
PAN HEAD WITH
LOCK WASHER (2)

Figure 5. Mounting the FT82011/FR82011 Module Using the Wall Clip

C2653M (6/07)

15

Image 15

Contents FT82011/FR82011 Ethernet Media Converter Page Contents List of IllustrationsList of Tables Important Safety Instructions Risk of Electric Shock Do not Open Radio and Television Interference Regulatory NoticesDescription Product OverviewC2653M 6/07 RK5000PS-5U rack mount chassis ModelsMultimode Models Single-Mode Models*†Front Panel Rear Panel 10BASE-T/100BASE-TX Ports 1-4, RJ-45 connectorsPackage Contents Installation10BASE-T/100BASE-TX Modes of Operation Flow control default settingMounting the FT82011/FR82011 Module Into a Rack MountingMounting the FT82011/FR82011 Module Using the Wall Clip Connections Fiber connection Troubleshooting Color Meaning Optic Fault LEDBudget specification stated Any of the following fault conditions If the cable isReceive optical signal Check for problemsLaser has reached end of life Meaning Possible Cause Corrective Action Optic Fault LEDAmber Is occurring Table C. Troubleshooting with Rear-Panel IndicatorsLished Is not desired, refer to the Setting AmberNot lit Meaning Possible CauseOccur on a half-duplex link Required Half-duplex Desired, no action is required. IfFull-duplex ModeOr if it is not the proper cable Mode Not desired, refer to the SettingColor Meaning Possible Cause Corrective Action Desired, no action is requiredNot lit Specifications Quality of ServiceWeighted fair queuing scheduling Multimode 62.5/125 μm Model Number Wavelength Optical Maximum Transmit/ReceiveReceiver EndNot used Appendix. RJ-45 Connector PinoutsC2653M 6/07 Product Warranty and Return Information ISO9001