Pelco FR82011 manual Rear Panel, 10BASE-T/100BASE-TX Ports 1-4, RJ-45 connectors

Page 11

REAR PANEL

Figure 3 illustrates the rear panel of the FT82011 and FR82011 modules.

FT82011

FR82011

Figure 3. Rear Panel of FT82011 and FR82011 Modules (SC Fiber Connector Shown)

ìRACK POWER/ALARM CONNECTOR, 4-pin connector for power/alarm connection of rack- mounted module

îSTAND-ALONE POWER CONNECTOR, 2-pin connector for power connection of stand-alone module; removable mating connector with screw terminals (not shown)

ï10BASE-T/100BASE-TX PORTS 1-4, RJ-45 connectors

ñFIBER OPTIC PORT, single-fiber ST or SC connector (dependent on FT82041/FR82041 model); port A on FT82041 module and port B on FR82041 module

óRJ-45 10BASE-T/100BASE-TX PORT STATUS LED, LEFT (link/activity status indicator)

rRJ-45 10BASE-T/100BASE-TX PORT STATUS LED, RIGHT (duplex mode/collision indicator)

For additional information about rear-panel connections, refer to the Installation section. For detailed information about the RJ-45 LEDs, refer to the Troubleshooting section.

C2653M (6/07)

11

Image 11

Contents FT82011/FR82011 Ethernet Media Converter Page List of Tables ContentsList of Illustrations Important Safety Instructions Risk of Electric Shock Do not Open Radio and Television Interference Regulatory NoticesDescription Product OverviewC2653M 6/07 RK5000PS-5U rack mount chassis ModelsMultimode Models Single-Mode Models*†Front Panel Rear Panel 10BASE-T/100BASE-TX Ports 1-4, RJ-45 connectorsPackage Contents Installation10BASE-T/100BASE-TX Modes of Operation Flow control default settingMounting the FT82011/FR82011 Module Into a Rack MountingMounting the FT82011/FR82011 Module Using the Wall Clip Connections Fiber connection Troubleshooting Color Meaning Optic Fault LEDBudget specification stated Any of the following fault conditions If the cable isReceive optical signal Check for problemsLaser has reached end of life Meaning Possible Cause Corrective Action Optic Fault LEDAmber Is occurring Table C. Troubleshooting with Rear-Panel IndicatorsLished Is not desired, refer to the Setting AmberNot lit Meaning Possible CauseOccur on a half-duplex link Required Half-duplex Desired, no action is required. IfFull-duplex ModeOr if it is not the proper cable Mode Not desired, refer to the SettingColor Meaning Possible Cause Corrective Action Desired, no action is requiredNot lit Weighted fair queuing scheduling SpecificationsQuality of Service Multimode 62.5/125 μm Model Number Wavelength Optical Maximum Transmit/ReceiveReceiver EndNot used Appendix. RJ-45 Connector PinoutsC2653M 6/07 Product Warranty and Return Information ISO9001