Sun Microsystems CP3000 manual Connector Locations and Assignments, Connector Pinouts

Page 54

A.1 Connector Locations and Assignments

This module is AMC.1 and AMC.3 compliant and can use ports 2 and 3, as defined in the AMC.3 specification.

Callout Port Function

12 AMC.3 Serial Storage Port 2

23 AMC.3 Serial Storage Port 3

34 AMC.1 PCI Express lane 0

45 AMC.1 PCI Express lane 1

56 AMC.1 PCI Express lane 2

67 AMC.1 PCI Express lane 3

A.2 Connector Pinouts

The AMC.1-HDD SAS disk includes an AMC connector, which conforms to the single-slot B+ extended connector, with 170 signal contacts.

The AMC.1-HDD SAS disk communicates with the carrier board through the AMC connectors. Connector usage for the AMC.1-HDD SAS disk is listed in the following table.

TABLE A-1Pin Assignments

Pin#	Signal Name	Pin#	Signal Name	Pin#	Signal Name	Pin#	Signal Name
1	GND	46	GND	91	No Connect	136	No Connect
2	12V	47	'PORT4_PCIe_RX0_P'	92	GND	137	GND
3	'PRSNT1_L'	48	'PORT4_PCIe_RX0_N'	93	No Connect	138	No Connect
4	'AMC_VCC3'	49	GND	94	No Connect	139	No Connect
5	GA0	50	'PCIe_TX1_P'	95	GND	140	GND
6	No Connect	51	'PCIe_TX1_N'	96	No Connect	141	No Connect
7	GND	52	GND	97	No Connect	142	No Connect
8	No Connect	53	'PCIe_RX1_P'	98	GND	143	GND

A-2Sun Netra CP3000 Advanced Mezzanine Card PCIe Hard Drive and SAS Controller User’s Guide • March 2010

Image 54

Contents For the AMC.1-HDD SAS Disk Please Recycle Contents Overview Managing the AMCEnvironment Specifications Configuring the AMCConnectors and Ports Agency CertificationsIndex Index-1 Preface Typographic ConventionsRelated Documentation Third-Party Web SitesSun Welcomes Your Comments Page Important Safety Information for Sun Hardware Systems Getting StartedChassis Compatibility System RequirementsOperating Systems Compatibility Blade Server CompatibilityUnpacking Electrical and EnvironmentalHandling AMCs AMC Faceplate 1AMC.1-HDD SAS Disk FaceplateAMC LEDs 1AMC Status LEDs2Hot-Swap Blue LED States Removing and Installing AMCs Removing an AMCShut down the payload OS Hot-Swap LED starts blinking 2Deactivating the AMC Remove the AMC 3Removing the AMCRemoving a Blade Server and AMC 4Front Cable Management Bracket in Lower PositionInstalling an AMC Remove the filler panel, if necessaryObtain the AMC card from the ship kit 5Sample Top View6Opening the Injector/Ejector Latch Page Push the ejector latch in fully 7Inserting the AMC Into a Blade ServerPower on the system, if necessary To Enable AMC Port 2 Driven by Port 1 of SAS ControllerTo Enable AMC Port 3 Driven by Port 2 of SAS Controller Enabling and Disabling SAS PortsTo Disable AMC Port 2 Driven by Port 1 of SAS Controller To Disable AMC Port 3 Driven by Port 2 of SAS ControllerPage Overview Features Power Regulator Key ComponentsHard Drive Disk SAS Controller FlashModule Management Controller MMC Port Connectors Faceplate and LEDsLEDs OOS Functional Diagram Technical Support and WarrantyPage 4Sun Netra CP3000 AMC.1-HDD SAS disk Barcode Labeling Disposal Managing the AMC Supported Ipmi Commands Monitoring and Control FunctionsIpmi Controller 1Supported Ipmi Commands FRU Information 2Standard FRU Data RecordsSensors 3Threshold SensorsFirmware and Software Upgrades Readme files within the download packageConfiguring the AMC Configuration Tools Boot Bios UtilityFeatures and Configurations Launching the Boot Bios UtilityPress Ctrl C Page OpenBoot Bios 2Adapter Properties MenuExtensible Firmware Interface EFI Enabling and Disabling Channel PortsConnectors and Ports Connector Locations and Assignments Connector PinoutsTable A-1Pin Assignments Appendix a Connectors and Ports SAS Controller Ports Keying Ports 1AMC e-Keying Port AssignmentsPage Environment Specifications Electrical and Environmental Table B-1Electrical SpecificationsTable B-2Environmental Specifications ElectricalTable B-3MTBF Values by Temperature RPMReliability Absolute Maximum RatingsNormal Operating Ranges Board Dimensions and Weight AMC.1-HDD SAS disk PCB DimensionsMechanical Page Agency Certifications CE Certification NEBS/ETSISafety Emissions Test Regulations 1 EN 55022 Emissions2 EN 55024 Immunity Regulatory Information FCC USAIndustry Canada Canada Page Index NumericsNEBS/ETSI, C-2