Sun Microsystems CP3000 manual Reliability, Absolute Maximum Ratings, Normal Operating Ranges

Page 62

B.1.3 Absolute Maximum Ratings

The following values are stress ratings only. Do not operate at these maximums. See Section B.1.4, “Normal Operating Ranges” on page B-4for normal operating conditions.

Payload voltage, +12V

0 VDC to +13.2 VDC

Management voltage, +3.3V

3.135 VDC to +3.465

 

VDC

Storage temperature

–40 to +70˚ Celsius

Noncondensing relative humidity

5% to 95% at 29˚ Celsius

 

 

B.1.4 Normal Operating Ranges

Description

Range

 

 

Nominal operating voltage

Operating temperatures*:

60m below sea level up to 1800m above sea level

from 1800m up to 4000m above sea level

Operating humidity

Idle power consumption (without links)

Maximum power consumption

+10.8 to +13.2 VDC payload power

3.135 VDC to +3.465 VDC management power

–5˚ to +55˚C

–5˚ to +40˚C

Less than 85% at 29˚C

9W

12W

*The MTBF will be significantly reduced if operated above 30˚C for more than 96 consecutive hours.

B.2 Reliability

Reliability prediction was done using Telcordia document SR-332, Issue 1. The prediction assumed 25˚ Celsius operating temperature with 100 percent duty cycle, in a ground-benign, controlled environment.

MTBF: 630,000 hours

One year limited warranty

B-4Sun Netra CP3000 Advanced Mezzanine Card PCIe Hard Drive and SAS Controller User’s Guide • March 2010

Image 62
Contents For the AMC.1-HDD SAS Disk Please Recycle Contents Overview Managing the AMCEnvironment Specifications Configuring the AMCConnectors and Ports Agency CertificationsIndex Index-1 Preface Typographic ConventionsRelated Documentation Third-Party Web SitesSun Welcomes Your Comments Page Important Safety Information for Sun Hardware Systems Getting StartedChassis Compatibility System RequirementsOperating Systems Compatibility Blade Server CompatibilityUnpacking Electrical and EnvironmentalHandling AMCs AMC Faceplate 1AMC.1-HDD SAS Disk FaceplateAMC LEDs 1AMC Status LEDs2Hot-Swap Blue LED States Shut down the payload OS Removing and Installing AMCsRemoving an AMC Hot-Swap LED starts blinking 2Deactivating the AMC Remove the AMC 3Removing the AMCRemoving a Blade Server and AMC 4Front Cable Management Bracket in Lower PositionInstalling an AMC Remove the filler panel, if necessaryObtain the AMC card from the ship kit 5Sample Top View6Opening the Injector/Ejector Latch Page Push the ejector latch in fully 7Inserting the AMC Into a Blade ServerPower on the system, if necessary To Enable AMC Port 2 Driven by Port 1 of SAS ControllerTo Enable AMC Port 3 Driven by Port 2 of SAS Controller Enabling and Disabling SAS PortsTo Disable AMC Port 2 Driven by Port 1 of SAS Controller To Disable AMC Port 3 Driven by Port 2 of SAS ControllerPage Overview Features Hard Drive Disk Power RegulatorKey Components Module Management Controller MMC SAS ControllerFlash LEDs Port ConnectorsFaceplate and LEDs OOS Functional Diagram Technical Support and WarrantyPage 4Sun Netra CP3000 AMC.1-HDD SAS disk Barcode Labeling Disposal Managing the AMC Ipmi Controller Supported Ipmi CommandsMonitoring and Control Functions 1Supported Ipmi Commands FRU Information 2Standard FRU Data RecordsSensors 3Threshold SensorsFirmware and Software Upgrades Readme files within the download packageConfiguring the AMC Configuration Tools Boot Bios UtilityPress Ctrl C Features and ConfigurationsLaunching the Boot Bios Utility Page OpenBoot Bios 2Adapter Properties MenuExtensible Firmware Interface EFI Enabling and Disabling Channel PortsConnectors and Ports Table A-1Pin Assignments Connector Locations and AssignmentsConnector Pinouts Appendix a Connectors and Ports SAS Controller Ports Keying Ports 1AMC e-Keying Port AssignmentsPage Environment Specifications Electrical and Environmental Table B-1Electrical SpecificationsTable B-2Environmental Specifications ElectricalTable B-3MTBF Values by Temperature RPMNormal Operating Ranges ReliabilityAbsolute Maximum Ratings Mechanical Board Dimensions and WeightAMC.1-HDD SAS disk PCB Dimensions Page Agency Certifications CE Certification NEBS/ETSISafety 2 EN 55024 Immunity Emissions Test Regulations1 EN 55022 Emissions Industry Canada Canada Regulatory InformationFCC USA Page Index NumericsNEBS/ETSI, C-2