Paradyne 8784 manual Device Messages 1 What Message Indicates What To Do

6. Messages and Troubleshooting

Device Messages

The Device Messages in Table 6-1, Device Messages, listed in alphabetical order, may appear in the messages area at the bottom of the ATI screens.

Table 6-1. Device Messages (1 of 2)

Device Message	What Message Indicates	What To Do
Access level is	The operator requested that	If configuration options are to be
Operator.	configuration options be	edited, use a Login ID that has
Configuration is	loaded, but does not have	Administrator authority.
read-only.	authority to edit them.
Cannot Save – no	All of the login IDs being	Change the access level of at
Login IDs with Access	saved have an access level	least one Login ID to
Administrator	below Administrator.	Administrator so that
		configuration changes can be
		made. (Operator-level users
		cannot make configuration
		changes.) Save the Login IDs.
Command Complete	Action requested has	No action is needed.
	successfully completed.
Invalid Character (x)	A nonprintable ASCII	Re-enter information using valid
	character (x) has been	characters.
	entered.
Invalid Password	Login is required and an	Try again.
	incorrect password was	Contact your system
	entered; access is denied.
		administrator to verify your
		password.
Invalid – Send Pattern	A pattern test was already in	Allow test to continue.
Already Active	progress when the Start field	Select another test.
	was selected.
		Stop the test.
Invalid – [Test] Already	The described test was	Allow test to continue.
Active	already in progress when	Select another test.
	another selection was made.
		Stop the test.
Invalid Test	A loopback or pattern test	Wait until other test ends and
Combination	was in progress when Start	message clears.
	was selected to start another	Abort all tests from the Test
	sametest, ororwasanotheractiveinterfaceon the
		Tmenu screen.
	when Start was selected.	Stop the test from the same
		screen the test was started
		from.
IP address not in	The Peer IP address	Enter an IP address that is in
MCC subnet	specified is not in the same	the same subnet as the MCC.
nnn.nnn.nnn.nnn	subnet as the MCC.

8784-A2-GB20-30 February 2001 6-3