Paradyne 8784 manual DSL Network IfIndex RFC

B. Standards Compliance for SNMP Traps

The tests that affect the enterpriseTestStart, enterpriseTestStop, and the variable-bindings are different for each particular interface. Diagnostic tests are only supported on the physical T1 network and user data port interfaces. The specific tests and variable-bindings are described in the following table:

	enterpriseTestStart/Stop
Interface	Variable-Bindings		Possible Cause
DSL Network	ifIndex (RFC 1573)		TenterpriseTest Start – Any
	ifAdminStatus (RFC 1573)		one of the following tests is
			active on the interface:
	ifOperStatus (RFC 1573)		–	Line Loopback
	TifType (RFC 1573)		–	Repeater Loopback
	ifTestType (RFC 1573)		–	Remote Line Loopback
			T–	Send and Monitor 511
	The following objects control tests
	in SNMP-managed devices:		enterpriseTest Stop – No
	– noTest – Stops the test in		tests currently running on
		progress.	the interface.
	– testLoopLLB – Initiates a Local
		Loopback.
	–	testLoopRLB – Initiates a
		Remote Loopback.
	–	testSendMon511 – Initiates a
		Send and Monitor 511 test.
	– testSendLLBUp – Initiates an
		LLB Up message to the
		remote unit.
	–	testSendLLBDown – Initiates
		an LLB Down message to the
		remote unit.
DSX-1	ifIndex (RFC 1573)		TenterpriseTest Start – Any
	ifAdminStatus (RFC 1573)		one of the following tests is
			active on the interface:
	TifOperStatus (RFC 1573)		–	Data Terminal
	ifTestType (RFC 1573)			Loopback
			–	Repeater Loopback
	The following objects control tests
			–	testLoop RLB – initiates
	in SNMP-managed devices:
	– noTest – Stops the test in			a Repeater Loopback
			–	testLoop DTLB –
		progress.
	–	testLoopExternalDTE		initiates a DSX-1 DTE
			T	Loopback
			enterpriseTest Stop – No
			tests currently running on
			the interface.

B-4 February 2001 8784-A2-GB20-30