Paradyne 8784 Copy Ports Options, Main Menu→ Configuration→ Current Configuration→ Copy Ports

A. Configuration Options

Copy Ports Options

You can copy the configuration options of one DSX-1 interface and DSL loop to another using the Copy Ports screen. For Copy Ports options, refer to Table A-3, Copy Ports Options. To access the Copy Ports screen, follow this menu selection sequence:

Main Menu→ Configuration→ Current Configuration→ Copy Ports

main/config/copy	Hotwire
Slot 4	Model: 8784

COPY PORTS

From: Port 1:

To: Port 2:

Perform Copy

Perform Copy Then Increment

--------------------------------------------------------------------------------

ESC for previous menu	MainMenu	Exit
Save

Table A-3. Copy Ports Options

From: Port n

Possible Settings: 1, 2

Default Setting: 1

Controls the source of the configuration options.

1 to 2 – The configuration of the selected port is copied.

To: Port y

Possible Settings: 1, 2, All

Default Setting: 2

Controls the target of the configuration options.

1 to 2 – The configuration of the selected port is replaced. If Perform Copy Then Increment is selected, the port number is incremented by 1 after the copy.

All – The configurations of all ports are replaced by the configuration of the selected

From: Port.

NOTE: Peer IP Address and Circuit Identifier are not copied.

8784-A2-GB20-30 February 2001 A-7