Patton electronic manual SmartNode 2292 and 2294 Leased-Line Extenders

Page 16

Model 2292 & 2294 Series Getting Started Guide	1 • General information

SmartNode 2292 and 2294 Leased-Line Extenders

The SmartNode 2292 and 2294 models are compact Leased-Line Extenderss over IP that support two or four VoIP channels, depending on the number of ports (see ﬁgure 2).

Model 2292

Ports

, 1.25A	Reset	ETH 0/1		ETH 0/0

Model 2294

Ports

, 1.25A	Reset		ETH 0/1			ETH 0/0

,1.25A

Reset

ETH	0/1

ETH

0/0

Ports

Figure 2. Examples of SmartNode 2292 and 2294 Series rear panels

The following base models (each equipped with two 10/100Base-T Ethernet ports) are available:

•SmartNode 2292/EUI (2 VoIP leased line channels)

•SmartNode 2294/EUI (4 VoIP leased line channels)

The port combinations are indicated in the extension of the model code. T he following model code conven- tions apply:

•The last number in the model code stands for the number of voice ports.

•EUI stands for external universal input power supply (see ﬁgure 3)

For example, the model code 2294/EUI describes a SmartNode conﬁgured as follows:

•4 voice ports

•External power supply

Note For a complete listing of available models, refer to the SmartNode

VoIP page at http://www.patton.com/voip/.

SmartNode Series Leased-Line Extenders overview

16

Image 16

Contents Model 2292 Mailsupport@patton.com Summary Table of Contents Table of Contents Compliance information List of Figures List of Tables Audience About this guideStructure Precautions Safety when working with electricity Preventing electrostatic discharge damage General observationsTypographical conventions used in this document General conventionsPage Chapter contents General informationSmartNode Series Leased-Line Extenders overview SmartNode extender SmartNode 2294 shownSmartNode 2292 and 2294 Leased-Line Extenders Examples of SmartNode 2292 and 2294 Series rear panelsReset button behavior Ports descriptionsSmartNode 2292 and 2294 front panels Applications overview Typical application Leased-line extensionHardware installation Planning the installation Create a network diagram see section Network information onInstallation checklist Task Veriﬁed by DatePower source Site logNetwork information IP related informationInstalling the SmartNode extender Connecting cablesLocation and mounting requirements Mounting the SmartNode extenderInstalling an interface cable on the extender’s voice ports RJ-11, malePin Signal Installing the Ethernet cable TX+Connecting to a host Connecting to external power source Power VoIP Link Enet Getting started with the SmartNode Introduction Connect the SmartNode to the networkConﬁgure the IP address Power connection and default conﬁgurationConnect with the serial interface Login LEDs status and monitoring Status LEDs LEDContacting Patton for assistance Warranty coverage Out-of-warranty serviceContact information Returns for creditRMA numbers Return for credit policyShipping instructions Appendix a Compliance information Compliance SafetyCE Declaration of Conformity Appendix B Speciﬁcations Data Services Quality of ServiceVoice Signaling CapacityTemperature Voice ProcessingManagement SystemAppendix C Cabling Connecting a serial terminal Serial consoleEthernet 10Base-T and 100Base-T Ethernet cross-overAnalog FXS Ethernet straight-throughAppendix D Port pin-outs Ethernet 10Base-T and 100Base-T port Console portVoice port Appendix E Installation checklist Installation checklist