Patton electronic 2292, 2294 manual Login

Page 35

Model 2292 & 2294 Series Getting Started Guide	4 • Getting started with the SmartNode

Login

1.Accessing your SmartNode via the local console port (or via a Telnet session) causes the login screen to dis- play. Type the factory default login: administrator and leave the password empty. Press the Enter key after the password prompt.

login:administrator

password: <Enter>

172.16.40.1>

2.After you have successfully logged in you are in the operator execution mode, indicated by > as command line prompt. With the commands enable and conﬁgure you enter the conﬁguration mode.

172.16.40.1>enable

172.16.40.1#configure

172.16.40.1(cfg)#

3.Enter the following commands for the ﬁrst SmartNode 229x device in the pair:

Copy nvram:a-side-config startup-config

Copy running-config startup-config

4.Follow the same procedure for the other SmartNode 229x device in the pair:

Copy nvram:b-side-config startup-config

Copy running-config startup-config

Note The conﬁguration above is only a sample conﬁguration that you may use as an example. You should specify your own parameters such as your IP address and other related parameters as required. For detailed information about conﬁguring and operating your SmartNode, set-up procedures, and trouble- shooting, refer to the SmartNode Series SmartWare Software Conﬁguration Guide on the CD-ROM that came with your unit.

5.Reboot both units and connect them back-to-back through their Ethernet 0/1 ports. Voice connections will automatically be set up between the units.

The steps above will conﬁgure the IP addresses as well as the required conﬁgurations for voice connections.

Configure the IP address

35

Image 35

Contents Model 2292 Mailsupport@patton.com Summary Table of Contents Table of Contents Compliance information List of Figures List of Tables Structure About this guideAudience Precautions Safety when working with electricity General observations Preventing electrostatic discharge damageGeneral conventions Typographical conventions used in this documentPage General information Chapter contentsSmartNode extender SmartNode 2294 shown SmartNode Series Leased-Line Extenders overviewExamples of SmartNode 2292 and 2294 Series rear panels SmartNode 2292 and 2294 Leased-Line ExtendersPorts descriptions Reset button behaviorSmartNode 2292 and 2294 front panels Applications overview Leased-line extension Typical applicationHardware installation Create a network diagram see section Network information on Planning the installationTask Veriﬁed by Date Installation checklistIP related information Power sourceSite log Network informationMounting the SmartNode extender Installing the SmartNode extenderConnecting cables Location and mounting requirementsRJ-11, male Installing an interface cable on the extender’s voice portsPin Signal TX+ Installing the Ethernet cableConnecting to a host Connecting to external power source Power VoIP Link Enet Getting started with the SmartNode Connect the SmartNode to the network IntroductionConnect with the serial interface Power connection and default conﬁgurationConﬁgure the IP address Login LEDs status and monitoring LED Status LEDsContacting Patton for assistance Returns for credit Warranty coverageOut-of-warranty service Contact informationShipping instructions Return for credit policyRMA numbers Appendix a Compliance information CE Declaration of Conformity SafetyCompliance Appendix B Speciﬁcations Capacity Data ServicesQuality of Service Voice SignalingSystem TemperatureVoice Processing ManagementAppendix C Cabling Serial console Connecting a serial terminalEthernet cross-over Ethernet 10Base-T and 100Base-TEthernet straight-through Analog FXSAppendix D Port pin-outs Voice port Console portEthernet 10Base-T and 100Base-T port Appendix E Installation checklist Installation checklist