Patton electronic 2292, 2294 manual Ports descriptions, Reset button behavior

Model 2292 & 2294 Series Getting Started Guide 1 • General information

External power supply connector (accepts 12 VDC, 1.25 A, from external AC adapter)

Ports

, 1.25A Reset ETH 0/1 ETH 0/0

,1.25A

Reset

ETH 0/1

ETH 0/0

Ports

Figure 3. SmartNode 2294 power input connectors

Ports descriptions

The SmartNode 2292 Series rear panel ports are described in table 2.

		Table 2. Rear panel ports
Port	Location	Description
10/100 Ethernet	Rear panel	RJ-45 connectors (see figure 6 on page 26) that connect the extender to an
ETH 0/0 & ETH 0/1		Ethernet device (e.g., a cable or DSL modem, LAN hub or switch).
Analog voice port	Rear panel	FXS RJ-11(6 position, 4 wire) connectors (see figure 6 on page 26) that
		connect the extender with an analog terminal.
Power	Rear panel	The gateway is available in a DC or AC power input version (see
		figure 3), labeled as follows:
		• AC version (Internal power supply): 100–240 VAC, 50/60 Hz, 200 mA
		• DC version: 12 VDC, 1.25 A
Console	Front panel	Used for service and maintenance, the Console port (see figure 4 on page 18),
		an RS-232 RJ-45 connector, connects the extender to a serial terminal such as a
		PC or ASCII terminal (also called a dumb terminal).

Reset button behavior

The SmartNode devices have a Reset button on the rear panel. It is used as follows:

•To restart the unit with the current startup configuration—Press for less than 1 second and release the Reset button. The SmartNode will restart with the current startup configuration.

•To restart the unit with factory default configuration—Press the Reset button for 5 seconds until the Power LED starts blinking. The unit will restart with factory default configuration.

SmartNode Series Leased-Line Extenders overview 17