Patton electronic 2294, 2292 manual Installing the Ethernet cable, Tx+

Page 28

Model 2292 & 2294 Series Getting Started Guide

3 • Hardware installation

 

 

Installing the Ethernet cable

The SmartNode 2292 Series has automatic MDX (auto-cross-over) detection and configuration on the Ether- net ports. Any of the two ports can be connected to a host or hub/switch with a straight-through wired cable (see figure 10 on page 28). Ethernet devices (10Base-T or 100Base-T) are connected to the SmartNode’s Ether- net ports (see table 6 for port pin-out listing) via a cable terminated with RJ-45 plugs. Because the SmartNode 2294 Series does not have the MDX feature, a cross-over cable is required when connecting SmartNode 2294 Series devices to a host (see figure 11 on page 29).

Table 6. Ethernet 10/100Base-T (RJ-45) port pin-outs (SmartNode 2294 Series)

Pin

Signal

 

 

1

TX+

 

 

2

TX-

 

 

3

RX+

 

 

6

RX-

 

 

Note Pins not listed are not used.

,1.25A

Reset

ETH

0/1

 

ETH

0/0

 

Ports

Hub

 

 

Straight-through cable

 

RJ-45, male

RJ-45, male

Tx+

1

1

Rx+

Tx-

2

2

Rx-

Rx+

3

3

Tx+

Rx-

6

6

Tx-

Figure 10. Connecting a SmartNode 2294 Series device to a hub

Installing the SmartNode extender

28

Page 27 Page 29
Image 28
Page 27 Page 29
Contents Model 2292 Mailsupport@patton.com Summary Table of Contents Table of Contents Compliance information List of Figures List of Tables Audience About this guideStructure Precautions Safety when working with electricity Preventing electrostatic discharge damage General observationsTypographical conventions used in this document General conventionsPage Chapter contents General informationSmartNode Series Leased-Line Extenders overview SmartNode extender SmartNode 2294 shownSmartNode 2292 and 2294 Leased-Line Extenders Examples of SmartNode 2292 and 2294 Series rear panelsReset button behavior Ports descriptionsSmartNode 2292 and 2294 front panels Applications overview Typical application Leased-line extensionHardware installation Planning the installation Create a network diagram see section Network information onInstallation checklist Task Verified by DatePower source Site logNetwork information IP related informationInstalling the SmartNode extender Connecting cablesLocation and mounting requirements Mounting the SmartNode extenderInstalling an interface cable on the extender’s voice ports RJ-11, malePin Signal Installing the Ethernet cable TX+Connecting to a host Connecting to external power source Power VoIP Link Enet Getting started with the SmartNode Introduction Connect the SmartNode to the networkConfigure the IP address Power connection and default configurationConnect with the serial interface Login LEDs status and monitoring Status LEDs LEDContacting Patton for assistance Warranty coverage Out-of-warranty serviceContact information Returns for creditRMA numbers Return for credit policyShipping instructions Appendix a Compliance information Compliance SafetyCE Declaration of Conformity Appendix B Specifications Data Services Quality of ServiceVoice Signaling CapacityTemperature Voice ProcessingManagement SystemAppendix C Cabling Connecting a serial terminal Serial consoleEthernet 10Base-T and 100Base-T Ethernet cross-overAnalog FXS Ethernet straight-throughAppendix D Port pin-outs Ethernet 10Base-T and 100Base-T port Console portVoice port Appendix E Installation checklist Installation checklist
Top Page Image Contents