Patton electronic 2294 Installing an interface cable on the extender’s voice ports, RJ-11, male

Page 26

Model 2292 & 2294 Series Getting Started Guide	3 • Hardware installation

Installing an interface cable on the extender’s voice ports

The SmartNode extender comes with at least two voice ports (see ﬁgure 6) located on the back of the extender. The voice ports are connected to analog devices via cables (see ﬁgure 7) terminated with RJ-11 connectors (see ﬁgure 9 and table 5 on page 27 for pin-out information).

Ethernet connectors	Voice ports

Ports

, 1.25A

Reset

ETH 0/1

ETH 0/0

,1.25A

Reset

ETH

0/1

ETH	0/0

Ports

Figure 6. Rear view showing location of Ethernet connectors and voice ports (SmartNode 2294 shown)

,1.25A

Reset

ETH	0/1

ETH	0/0

Ports

RJ-11, male		RJ-11, male

Figure 7. Analog connection

Installing the SmartNode extender

26

Image 26

Contents Model 2292 Mailsupport@patton.com Summary Table of Contents Table of Contents Compliance information List of Figures List of Tables Structure About this guideAudience Precautions Safety when working with electricity Preventing electrostatic discharge damage General observationsTypographical conventions used in this document General conventionsPage Chapter contents General informationSmartNode Series Leased-Line Extenders overview SmartNode extender SmartNode 2294 shownSmartNode 2292 and 2294 Leased-Line Extenders Examples of SmartNode 2292 and 2294 Series rear panelsReset button behavior Ports descriptionsSmartNode 2292 and 2294 front panels Applications overview Typical application Leased-line extensionHardware installation Planning the installation Create a network diagram see section Network information onInstallation checklist Task Veriﬁed by DateNetwork information Power sourceSite log IP related informationLocation and mounting requirements Installing the SmartNode extenderConnecting cables Mounting the SmartNode extenderInstalling an interface cable on the extender’s voice ports RJ-11, malePin Signal Installing the Ethernet cable TX+Connecting to a host Connecting to external power source Power VoIP Link Enet Getting started with the SmartNode Introduction Connect the SmartNode to the networkConnect with the serial interface Power connection and default conﬁgurationConﬁgure the IP address Login LEDs status and monitoring Status LEDs LEDContacting Patton for assistance Contact information Warranty coverageOut-of-warranty service Returns for creditShipping instructions Return for credit policyRMA numbers Appendix a Compliance information CE Declaration of Conformity SafetyCompliance Appendix B Speciﬁcations Voice Signaling Data ServicesQuality of Service CapacityManagement TemperatureVoice Processing SystemAppendix C Cabling Connecting a serial terminal Serial consoleEthernet 10Base-T and 100Base-T Ethernet cross-overAnalog FXS Ethernet straight-throughAppendix D Port pin-outs Voice port Console portEthernet 10Base-T and 100Base-T port Appendix E Installation checklist Installation checklist