Patton electronic 2292, 2294 manual Console port, Ethernet 10Base-T and 100Base-T port, Voice port

Page 51

Model 2292 & 2294 Series Getting Started Guide

D • Port pin-outs

 

 

Introduction

This section provides pin-out information for the ports of the SmartNode.

Console port

Figure 21. EIA-561 (RJ-45 8-pin) port

Note Pins not listed are not used.

Ethernet 10Base-T and 100Base-T port

Table 9. RJ-45 socket

Pin

Signal

 

 

1

TX+

 

 

2

TX-

 

 

3

RX+

 

 

6

RX-

 

 

Note Pins not listed are not used.

Voice port

The voice ports use an RJ-11 connector with 6 positions. The midle two positions 3 and 4 are used according to table 10.

Table 10. RJ-11 socket

Pin

Signal

3Ring (-)

4Tip (+)

Note Pins not listed are not used.

Introduction

51

Image 51
Contents Model 2292 Mailsupport@patton.com Summary Table of Contents Table of Contents Compliance information List of Figures List of Tables About this guide AudienceStructure Precautions Safety when working with electricity General observations Preventing electrostatic discharge damageGeneral conventions Typographical conventions used in this documentPage General information Chapter contentsSmartNode extender SmartNode 2294 shown SmartNode Series Leased-Line Extenders overviewExamples of SmartNode 2292 and 2294 Series rear panels SmartNode 2292 and 2294 Leased-Line ExtendersPorts descriptions Reset button behaviorSmartNode 2292 and 2294 front panels Applications overview Leased-line extension Typical applicationHardware installation Create a network diagram see section Network information on Planning the installationTask Verified by Date Installation checklistIP related information Power sourceSite log Network informationMounting the SmartNode extender Installing the SmartNode extenderConnecting cables Location and mounting requirementsRJ-11, male Installing an interface cable on the extender’s voice portsPin Signal TX+ Installing the Ethernet cableConnecting to a host Connecting to external power source Power VoIP Link Enet Getting started with the SmartNode Connect the SmartNode to the network IntroductionPower connection and default configuration Configure the IP addressConnect with the serial interface Login LEDs status and monitoring LED Status LEDsContacting Patton for assistance Returns for credit Warranty coverageOut-of-warranty service Contact informationReturn for credit policy RMA numbersShipping instructions Appendix a Compliance information Safety ComplianceCE Declaration of Conformity Appendix B Specifications Capacity Data ServicesQuality of Service Voice SignalingSystem TemperatureVoice Processing ManagementAppendix C Cabling Serial console Connecting a serial terminalEthernet cross-over Ethernet 10Base-T and 100Base-TEthernet straight-through Analog FXSAppendix D Port pin-outs Console port Ethernet 10Base-T and 100Base-T portVoice port Appendix E Installation checklist Installation checklist