Patton electronic 2292, 2294 manual Analog FXS, Ethernet straight-through

Page 49

Model 2292 & 2294 Series Getting Started Guide

C • Cabling

,1.25A

Reset

ETH	0/1

ETH	0/0

Ports

Hub

		Straight-through cable
RJ-45, male		RJ-45, male
Tx+	1	1	Rx+
Tx-	2	2	Rx-
Rx+	3	3	Tx+
Rx-	6	6	Tx-

Figure 19. Ethernet straight-through

Analog FXS

Applicable to SmartNodes equipped with FXS ports. The FXS ports are connected to analog terminals (phones, fax machines, answering machines) via cables terminated with RJ-11 connectors (see section “Voice port” on page 51 for details on port pinouts).

,1.25A

Reset

ETH	0/1

ETH	0/0

Ports

RJ-11, male		RJ-11, male

Figure 20. Connecting an FXS device

Analog FXS

49

Image 49

Contents Model 2292 Mailsupport@patton.com Summary Table of Contents Table of Contents Compliance information List of Figures List of Tables Audience About this guideStructure Precautions Safety when working with electricity General observations Preventing electrostatic discharge damageGeneral conventions Typographical conventions used in this documentPage General information Chapter contentsSmartNode extender SmartNode 2294 shown SmartNode Series Leased-Line Extenders overviewExamples of SmartNode 2292 and 2294 Series rear panels SmartNode 2292 and 2294 Leased-Line ExtendersPorts descriptions Reset button behaviorSmartNode 2292 and 2294 front panels Applications overview Leased-line extension Typical applicationHardware installation Create a network diagram see section Network information on Planning the installationTask Veriﬁed by Date Installation checklistSite log Power sourceNetwork information IP related informationConnecting cables Installing the SmartNode extenderLocation and mounting requirements Mounting the SmartNode extenderRJ-11, male Installing an interface cable on the extender’s voice portsPin Signal TX+ Installing the Ethernet cableConnecting to a host Connecting to external power source Power VoIP Link Enet Getting started with the SmartNode Connect the SmartNode to the network IntroductionConﬁgure the IP address Power connection and default conﬁgurationConnect with the serial interface Login LEDs status and monitoring LED Status LEDsContacting Patton for assistance Out-of-warranty service Warranty coverageContact information Returns for creditRMA numbers Return for credit policyShipping instructions Appendix a Compliance information Compliance SafetyCE Declaration of Conformity Appendix B Speciﬁcations Quality of Service Data ServicesVoice Signaling CapacityVoice Processing TemperatureManagement SystemAppendix C Cabling Serial console Connecting a serial terminalEthernet cross-over Ethernet 10Base-T and 100Base-TEthernet straight-through Analog FXSAppendix D Port pin-outs Ethernet 10Base-T and 100Base-T port Console portVoice port Appendix E Installation checklist Installation checklist