Patton electronic 2294, 2292 manual Ethernet 10Base-T and 100Base-T, Ethernet cross-over

Page 48

Model 2292 & 2294 Series Getting Started Guide	C • Cabling

Ethernet 10Base-T and 100Base-T

Ethernet devices (10Base-T/100Base-T) are connected to the SmartNode over a cable with RJ-45 plugs. Use a cross-over cable to a host, or a straight cable to a hub. See ﬁgure 18 (host) and ﬁgure 19 on page 49 (hub) for the different connections.

Note The SmartNode 2292 Series is equipped with Auto-MDX Ethernet ports.

Use straight-through wired cables for host or hub/switch connections

,1.25A

Reset

ETH	0/1

ETH	0/0

Ports

Host

		Cross-over cable
RJ-45, male		RJ-45,
Tx+	1	1	TX+
Twisted pair 1	2	2	TX-
Tx-
Rx+	3	3	RX+
Twisted pair 2	6	6	RX-
Rx-

Figure 18. Ethernet cross-over

Ethernet 10Base-T and 100Base-T

48

Image 48

Contents Model 2292 Mailsupport@patton.com Summary Table of Contents Table of Contents Compliance information List of Figures List of Tables About this guide AudienceStructure Precautions Safety when working with electricity Preventing electrostatic discharge damage General observationsTypographical conventions used in this document General conventionsPage Chapter contents General informationSmartNode Series Leased-Line Extenders overview SmartNode extender SmartNode 2294 shownSmartNode 2292 and 2294 Leased-Line Extenders Examples of SmartNode 2292 and 2294 Series rear panelsReset button behavior Ports descriptionsSmartNode 2292 and 2294 front panels Applications overview Typical application Leased-line extensionHardware installation Planning the installation Create a network diagram see section Network information onInstallation checklist Task Veriﬁed by DatePower source Site logNetwork information IP related informationInstalling the SmartNode extender Connecting cablesLocation and mounting requirements Mounting the SmartNode extenderInstalling an interface cable on the extender’s voice ports RJ-11, malePin Signal Installing the Ethernet cable TX+Connecting to a host Connecting to external power source Power VoIP Link Enet Getting started with the SmartNode Introduction Connect the SmartNode to the networkPower connection and default conﬁguration Conﬁgure the IP addressConnect with the serial interface Login LEDs status and monitoring Status LEDs LEDContacting Patton for assistance Warranty coverage Out-of-warranty serviceContact information Returns for creditReturn for credit policy RMA numbersShipping instructions Appendix a Compliance information Safety ComplianceCE Declaration of Conformity Appendix B Speciﬁcations Data Services Quality of ServiceVoice Signaling CapacityTemperature Voice ProcessingManagement SystemAppendix C Cabling Connecting a serial terminal Serial consoleEthernet 10Base-T and 100Base-T Ethernet cross-overAnalog FXS Ethernet straight-throughAppendix D Port pin-outs Console port Ethernet 10Base-T and 100Base-T portVoice port Appendix E Installation checklist Installation checklist