Patton electronic 2294, 2292 manual Connecting to external power source

Page 30

Model 2292 & 2294 Series Getting Started Guide	3 • Hardware installation

Connecting to external power source

The extender comes with an external power supply. This section describes installing the power cord into the extender. Do the following:

Note Do not connect the power cord to the power outlet at this time.

1.Insert the barrel type connector end of the AC power cord into the external power supply connector (see ﬁgure 12).

External power supply connector (accepts 12 VDC, 1.25 A, from external AC adapter)

Ports

, 1.25A

Reset

ETH 0/1

ETH 0/0

,1.25A

Reset

ETH

0/1

ETH

0/0

Ports

Figure 12. Power connector location on rear panel

The extender power supply automatically adjusts to accept an input voltage from 100 to 240 VAC (50/60 Hz).

Verify that the proper voltage is present before plugging the power cord into the receptacle. Failure to do so could result in equipment damage.

2.Verify that the AC power cord included with your extender is compatible with local standards. If it is not, refer to “Contacting Patton for assistance” on page 38 to ﬁnd out how to replace it with a compatible power cord.

3.Connect the male end of the power cord to an appropriate power outlet.

Installing the SmartNode extender

30

Image 30

Contents Model 2292 Mailsupport@patton.com Summary Table of Contents Table of Contents Compliance information List of Figures List of Tables About this guide AudienceStructure Precautions Safety when working with electricity Preventing electrostatic discharge damage General observationsTypographical conventions used in this document General conventionsPage Chapter contents General informationSmartNode Series Leased-Line Extenders overview SmartNode extender SmartNode 2294 shownSmartNode 2292 and 2294 Leased-Line Extenders Examples of SmartNode 2292 and 2294 Series rear panelsReset button behavior Ports descriptionsSmartNode 2292 and 2294 front panels Applications overview Typical application Leased-line extensionHardware installation Planning the installation Create a network diagram see section Network information onInstallation checklist Task Veriﬁed by DateNetwork information Power sourceSite log IP related informationLocation and mounting requirements Installing the SmartNode extenderConnecting cables Mounting the SmartNode extenderInstalling an interface cable on the extender’s voice ports RJ-11, malePin Signal Installing the Ethernet cable TX+Connecting to a host Connecting to external power source Power VoIP Link Enet Getting started with the SmartNode Introduction Connect the SmartNode to the networkPower connection and default conﬁguration Conﬁgure the IP addressConnect with the serial interface Login LEDs status and monitoring Status LEDs LEDContacting Patton for assistance Contact information Warranty coverageOut-of-warranty service Returns for creditReturn for credit policy RMA numbersShipping instructions Appendix a Compliance information Safety ComplianceCE Declaration of Conformity Appendix B Speciﬁcations Voice Signaling Data ServicesQuality of Service CapacityManagement TemperatureVoice Processing SystemAppendix C Cabling Connecting a serial terminal Serial consoleEthernet 10Base-T and 100Base-T Ethernet cross-overAnalog FXS Ethernet straight-throughAppendix D Port pin-outs Console port Ethernet 10Base-T and 100Base-T portVoice port Appendix E Installation checklist Installation checklist