Patton electronic 4020 Series manual Phone 1 & Phone, FAX without T.38 Use G.711 fax

SmartLink 4020 Getting Started Guide 6 • Telephony

FAX without T.38 (Use G.711 fax)

When checked, T.38 is disabled and the SL4020 will not attempt T.38 session negotiation for fax transmissions initiated by the originator of the fax. The fax transmissions will be transported using G.711 fax pass-through. The selection of T.38 or G.711 fax pass-through for fax transmissions originated from the SL4020 will be determined by the receiving fax device. T.38 is enabled by default.

To disable T.38, go to Telephony > CODECS and select FAX without T.38 (Use G.711 fax) (see figure 30 on page 54).

Saving your work

When you are finished configuring CODEC settings, click the Save CODEC Configuration button (see figure 30 on page 54) to save the changes.

Phone 1 & Phone 2

The Phone 1 and Phone 2 windows contains the following sections:

•User Information (see figure 31)

•Supplementary Service Settings (see figure 32 on page 57)

•Dial Out Type (see figure 33 on page 58)

•Call Forward Settings (see figure 27 on page 52)

•Selective Call Forward Settings (see figure 28 on page 52)

•Incoming Call Block (see figure 29 on page 53)

•Distinctive Ring Settings (see figure 29 on page 53)

•HTTP Digest Setting (see figure 29 on page 53)

Note After configuring the sections, click the Save button (see figure 38 on page 60) to save the new configuration.

Phone 1 & Phone 2 55