Patton electronic 4020 Series manual Call Progress Tones, Dial Tone, Prompt Tone, Confirm Tone

SmartLink 4020 Getting Started Guide 7 • System

Call Progress Tones

The dialtone, confirmation, busy, ringback and offhook warning call progress tones that are played to the handset can be set manually or the tones will be set automatically to the country specified under Call ID method if the checkbox, Call Progress Tones synchronization has been selected.

To set the call progress tones manually specify:

[frequency 1]@[Energy 1]+[frequency 2]@[Energy 2]#ON([ms]),OFF([ms]),R

Where:

•Frequency 1 and frequency 2 are the frequency of the tone to be played.

•Energy 1 and energy 2 are the energy level of the tone to be played in dBm.

•ON(ms) is the duration that the tone will be played in milliseconds.

•OFF(ms) is the duration of the pause between cycles of playing the tone.

•R indicates the tone should be repeated using the ON and OFF durations specified

To specify a 350-Hz and 480-Hz tone that will be played at 15 dB for one second and then pause for 0.5 sec- onds, you would specify:

350@-15+480@-15#ON(1000),OFF(500),R

The following example would repeat playing of a tone of 280 Hz at -8 dBm for 0.3 seconds with a pause of 0.1 second and a tone of 550 Hz for 0.8 seconds with a pause of 0.15 seconds.

280@-8+550@-20#ON(300),OFF(100),ON(800),OFF(150),R

Figure 43. Call Progress Tones section of Localization window

Dial Tone

Played when prompting the user to enter a phone number.

Prompt Tone

Played when prompting the user to enter a call forward phone number.

Confirm Tone

This should be a brief tone to notify the user that the last input value has been accepted.

Holding Tone

Indicate to the local user that the far end has placed the call on hold.

Localization 69