TP-Link TL-SL2428WEB/TL-SL2452WEB, TL-SL2210WEB/TL-SL2218WEB manual Reset

Gigabit Uplink Web Smart Switch

RESET

Press this button for three seconds to reset the software setting back to factory default setting.

LEDs

LED	Status	Indication
Power	On	The Switch is powered on
	Off	The Switch is powered off or power supply is abnormal
System	On	The Switch works properly
	Off	The Switch works improperly
	On	A valid link is established on the port
Link/Act	Flashing	Data is being transmitted or received. (SFP port has Link/
		Act LED only and must connect to 1000Mbps device.1
	Off	No device is connected to the corresponding port
	On	The corresponding port is running at 100Mbps
100Mbps	Off	There is no device linked to the corresponding port or the
		port is running at 10Mbps
	On	The corresponding port is running at 1000Mbps
1000Mbps
	Off	There is no device linked to the corresponding port or the
		port is running at 100Mbps

Port Feature

Model	10/100Mbps RJ45 Port	10/100/1000Mbps RJ45 Port	SFP Port
TL-SL2210WEB	8	1	1
TL-SL2218WEB	16	1	1
TL-SL2428WEB	24	2	2
TL-SL2452WEB	48	2	2

10/100Mbps RJ45 Port

Designed to connect to the device with the bandwidth of 10Mbps or 100Mbps. Each port has a corresponding Link/Act and 100Mbps LED.

10/100/1000Mbps RJ45 Port

Designed to connect to the device with the bandwidth of 10Mbps, 100Mbps or 1000Mbps. It has a corresponding Link/Act and 1000Mbps LED.

SFP Port

Designed to install SFP module. It has a corresponding Link/Act LED.

03 Introduction