TP-Link TL-SL2210WEB/TL-SL2218WEB, TL-SL2428WEB/TL-SL2452WEB manual 66666666Port Description

Page 41

Gigabit Uplink Web Smart Switch

FFFFFFFFFFFFStorm Control

¾¾ Broadcast Control: Enable or disable the broadcast control to limit the broadcast frames.

¾¾ Multicast Control: Enable or disable the multicast control to limit the multicast frames. Enabling multicast control will also enable broadcast control.

¾¾ UL Control: Enable or disable the UL control to limit the UL packets. Enabling UL control will also enable broadcast control and multicast control.

¾¾ Limit Rate: Indicates the maximum rate (kilobytes per second\ at which the controlled packets configured above are forwarded. For the 1000Mbps port, if set the value of 64Kbps, the actual value is about 70Kbps.

Note: Parameters of Trunk member ports display the parameters of the Trunk they belong to and it cannot be configured here (see port 5 and 6 in Figure 6-25 for example\. You can configure parameters of the Trunk in the “Port Trunking” page.

66666666Port Description

This page configures the description to indicate the ports.

Input description words in the Description filed for each port. Notice that at most 15 letters or numbers can be held in each field.

FFFFFFFFFFFFPort Description

Web Management 34

Image 41

Contents User Guide Page CE Mark Warning Copyright & Trademarks FCC StatementRelated Document About this User Guide Conventions AudienceContents WEB Management Product Overview FeaturesCccccccccc Introduction Front Panel AppearanceReset Rear Panel Safety Precautions CCCCCCCCCCInstallationPackage Contents Site Requirements Lightening Protection Product Installation Installation ToolsFffffffffff Bracket Installation Cabling Reasonably Cccccccccc Lightning ProtectionRequirements for Cabling Indoors Connect to Ground SFP Port CCCCCCCCCCConnectionEthernet Port Power On Verify InstallationCCCCCCCCCCFunction Description Port Security Flow ControlPort Statistic and Port Status Storm ControlAging Time and Dynamic Address Table Network SettingDynamic Binding Static MAC Address TableFiltering MAC Address Table Ping Vlan SettingVlan Mode Port-Based Priority Priority Setting Priority ModePort Trunking 555555 802.1p Priority Port Default PriorityPort Mirroring Virtual Cable TestOverview Connecting to the Device Getting StartedCcccccccccweb Management Fffffffffff Settings Dialog Dialog will pop up as below Setting the Device Login the SwitchGigabit Uplink Web Smart Switch ¾¾ Port Trunking Port Trunking System Information Further explanation Port Setting Ffffffffffff Port Parameter 66666666Port Statistic 66666666Storm Control Port Status66666666Port Description Static MAC Address Switch IP AddressFFFFFFFFFFFFStatic MAC address Filtering MAC Address 66666666Dynamic Binding Bound MAC Address Aging Time Vlan Setting Vlan Mode 66666666Port Vlan Setting 66666666Tag Vlan Global Setting 66666666Tag Vlan Setting MTU Vlan Setting Priority Setting 66666666Port-Based Priority 66666666802.1p Priority Class FFFFFFFFFFFFVirtual Cable Test Qqqq Why does the Power LED work abnormally? Appendix a TroubleshootingAppendix B Table of Factory Defaults Pvid Appendix C Table of Function Differences of Switch Family FCC, CE Appendix D Hardware SpecificationsAppendix E Technical Support Page 7106503690 Rev