Canon LV-5220, LV-7225, LV-7220 owner manual To the Owner, Risk of Electric Shock Do not Open

Page 4

To the Owner

Before operating this projector, read this manual thoroughly and operate the projector properly.

This projector provides many convenient features and functions. Operating the projector properly enables you to manage those features and maintains it in better condition for a considerable time.

Improper operation may result in not only shortening the product-life, but also malfunctions, fire hazard, or other accidents.

If your projector seems to operate improperly, read this manual again, check operations and cable connections and try the solutions in the “Troubleshooting” section in the end of this booklet. If the problem still persists, contact the dealer where you purchased the projector or the service center.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE EXCEPT LAMP REPLACEMENT. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

THIS SYMBOL INDICATES THAT DANGEROUS VOLTAGE CONSTITUTING A RISK OF ELECTRIC SHOCK IS PRESENT WITHIN THIS UNIT.

THIS SYMBOL INDICATES THAT THERE ARE IMPORTANT OPERATING AND MAINTENANCE INSTRUCTIONS IN THE OWNER'S MANUAL WITH THIS UNIT.

Safety Precaution

WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

This projector produces intense light from the projection lens. Do not stare directly into the lens as possible. Eye damage could result. Be especially careful that children do not stare directly into the beam.

Install the projector in a proper position. If not, it may result in a fire hazard.

Provide appropriate space on the top, sides and rear of the projector cabinet for allowing air circulation and cooling the projector. Minimum clearance must be maintained. If the projector is to be built into a compartment or similarly enclosed, the minimum distances must be maintained. Do not cover the ventilation slot on the projector. Heat build- up can reduce the service life of your projector, and can also be dangerous.

SIDE and TOP

REAR

3.3'(1m)

3.3'(1m)

3.3'(1m)

3.3'(1m)

Do not put any flammable object or spray can near the projector, hot air is exhausted from the ventilation holes.

If the projector is not to be used for an extended time, unplug the projector from the power outlet.

READ AND KEEP THIS OWNER'S MANUAL FOR LATER USE.

CAUTION

Not for use in a computer room as defined in the Standard for the Protection of Electronic Computer/Data Processing Equipment, ANSI/NFPA 75.

Ne puet être utillisé dans une salle d’ordinateurs telle que définie dans la norme ANSI/NFPA 75 Standard for Protection of Electronic Computer/Data Processing Equipment

NOTE FOR CUSTOMERS IN THE US

Hg LAMP(S) INSIDE THIS PRODUCT CONTAIN MERCURY AND MUST BE RECYCLED OR DISPOSED OF ACCORDING TO LOCAL, STATE OR FEDERAL LAWS.

For use in Netherlands

Bij dit produkt zijn batterijen geleverd.

Wanneer deze leeg zijn, moet u ze niet weggooien maar inleveren

NL als KCA.

4

Image 4
Contents LV-7225LV-7220LV-5220 Blackboard can be used as a projection screen Features and DesignSee page 32 Table of Contents To the Owner Risk of Electric Shock Do not OpenSafety Instructions Hinweise für DeutschlandAir Circulation Installing the Projector in Proper PositionMoving the Projector Compliance Federal Communication Commission NoticeFront Back Bottom Part Names and FunctionsLens Cover See page 50 for attaching Rear Terminal Top Control Remote Control Unit Signal Emission indicatorLaser Pointer Function Pointer FunctionWireless Mouse Operation Operating RangeRemote Control Code Remote Control Battery InstallationButton. The code switches sequentially for one pressing With holding down the Menu button, press the ImageAdjustable Feet InstallationPositioning the Projector For the U.S.A. and Canada For Continental Europe Connecting the AC Power Cord200 240 V AC Connecting to a Computer Cables used for connectionConnecting to Video Equipment StereoConnecting to Component Video Equipment Component RGB OUTWhat is PIN code? Basic OperationTurning On the Projector Enter a PIN codeWhen the projector has cooled down enough to be turned on Again, the Power indicator lights red. Then you canDisconnect the AC power cord Turning Off the ProjectorHow to Operate the On-Screen Menu Remote Control UnitOn-Screen Menu Top ControlMenu Bar PC System MenuZoom and Focus Adjustment Auto Setup FunctionPicture Freeze Function Keystone AdjustmentNo Show Function Timer Function Sound AdjustmentVolume MuteComputer Input Input Source SelectionAuto Computer System SelectionMode Auto PC Adjustment To store adjustment parametersPC Adjust Menu Auto PC AdjManual PC Adjustment Reset Mode freeDisplay area Display area HImage Level Selection StandardHigh contrast BlackboardGreenImage Level Adjustment Screen Size Adjustment Video Input Input Source Selection Video, S-VideoInput button Video Computer Video button Source Select Menu VideoInput Source Selection Component, RGB Scart 21-Pin Input button Computer Video Computer buttonVideo System Selection AutoAV System Menu Video or S-Video AV System Menu ComponentPicture level adjusted for the picture with fine tone User preset image in the Image Adjust Menu p39Cinema Image button Standard Cinema BlackboardGreen CustomTint ColorPress the Point 78 button to obtain proper color. From 0 to Progressive Resets all adjustment to their previous figureFilm Provides image at a normal video aspect ratio of 4 Provides image at a wide screen ratio of 16Setting SettingAuto setup LanguageBlue back DisplayLogo PIN code lock Enter a Logo PIN codeLogo CaptureCeiling RearStandby mode Power managementLamp mode On startRemote control PointerUSB Key lockPIN code lock To Change the PIN code lock settingTo Change the PIN code Lamp counter reset Factory defaultFan Factory default FanProjector is shut down and the Warning indicator lights red Maintenance and CleaningThen check the matters below Cleaning the Air Filters Attaching the Lens CoverCleaning the Projection Lens Cleaning the Projector CabinetLamp Replacement Reset the Lamp replace counterWhen the lamp replace counter is reset, the Lamp Lamp Replace CounterTroubleshooting AppendixRemote Control Unit does not work. Check the batteries AppendixMenu Tree Setting Image Select Image Adjust ScreenIndicators and Projector Condition Freq Compatible Computer SpecificationsKHz Technical Specifications Optional Parts LV-CA31 Not available in the U.S.AThis cable is used for RGB 21-Pin Video output of video equipmentConfigurations of Terminals USB Connector Series BTerminal HDB15-PIN Terminal DVI-IWhile the projector is locked with the PIN code Canon Communication & Image France S.A 1AA6P1P4619--MT7P