Dukane 8915 user manual Remote control, Laser pointer, Putting batteries

Page 26

Remote control

Remote control

Laser pointer

WARNING ►The laser pointer of the remote control is used in place of a ﬁnger or rod. Never look directly into the laser beam outlet or point the laser beam at other people. The laser beam can cause vision problems.

CAUTION ►Use of controls or adjustments or performance of procedures other than those speciﬁed herein may result in hazardous radiation exposure.

EO

VID

STANDBY/ON

RGB

UP
GE
PA	N
DOW

LASER

BLANK

T

ASPEC

RESET

	U
R	MEN
ENTE
ESC	O
	AUT
POSITION
	Y
	AGNIF
	M ON
	OFF

	UME
VOL
	MUTE
E
FREEZ	ONETOUCH
	ONE
KEYST

This remote control has a laser pointer in place of a ﬁnger or rod. The laser beam works and theLASER INDICATOR lights while the LASER button is pressed.

Putting batteries

WARNING ►Always handle the batteries with care and use them only as directed. Improper use may result in battery explosion, cracking or leakage, which could result in ﬁre, injury and/or pollution of the surrounding environment.

•Be sure to use only the batteries speciﬁed. Do not use batteries of different types at the same time. Do not mix a new battery with used one.

•Make sure the plus and minus terminals are correctly aligned when loading a battery.

•Keep a battery away from children and pets.

•Do not recharge, short circuit, solder or disassemble a battery.

•Do not allow a battery in a ﬁre or water. Keep batteries in a dark, cool and dry place.

•If you observe a leakage of a battery, wipe out the ﬂower and then replace a battery. If the ﬂower adheres your body or clothes, rinse well with water immediately.

1. Remove the battery cover.

Slide back and remove the battery cover in the direction of the arrow.

2. Insert the batteries.

Align and insert the two AA batteries according to their plus and minus terminals as indicated in the remote control.

3. Close the battery cover.

Replace the battery cover in the direction of the arrow and snap it back into place.

14

Image 26

Contents LCD Projector Model Page About The Symbols Safety Precautions Safety Precautions Be careful in handling the light source lamp Be careful in moving the projector Do not give the remote control any physical impact Take care not to fatigue your eyes Lamp Regulatory Notices Page Trademark acknowledgment About this manualThank you for purchasing this projector Contents About contents of package Fastening the lens cap Component Part namesProjector P B P RControl buttons Remote controlLaser Indicator 14 STANDBY/ONSetting up At 169 screen ArrangementAt 43 screen Adjusting the projectors elevator About the ﬁlter cover for bottom-up use Connecting your devices About Plug-and-Play capabilityExamples of connection with a computer Connecting to a monitor outputConnecting to a speaker with ampliﬁer output Component video out RGB cable RGB out LAN portLAN cable CAT-5 CB/PBConnecting power supply Putting batteries Remote controlLaser pointer Using the remote control Turning off the power Power on/offTurning on the power STANDBY/ONOperating Adjusting the volumeSelecting an input signal Temporarily muting the soundPress the ONE Touch button on the remote control. This Adjusting screen with ONE-TOUCHAdjusting the zoom and focus Selecting an aspect ratio At a RGB signal Using the automatic adjustment featureAdjusting the position  At a video signalUsing the magnify feature Correcting the keystone distortionsFreezing the screen Temporarily blanking the screenUSB mouse and keyboard control Available function Remote control operationOperating the computer screen At the Easy Menu Multifunctional settingsUsing the menu function At the advanced MenuEasy Menu Mirror ResetEasy Menu Filter TimePicture Menu GammaColor Temp Picture MenuHigh  Middle  LOW  Custom SharpnessMY Memory LOAD1  LOAD2  LOAD3  LOAD4SAVE4 SAVE3  SAVE2  SAVE1 Over Scan PhaseImage Menu PositionSize Auto AdjustImage Menu Execute3D-YCS Video Qlty. MenuProgressive Video NRDVI Input MenuVideo Format Input Menu InformationStereo Setup MenuVolume IR RemoteOSD Bright Screen MenuMenu Position Bright  DarkMy Screen Screen MenuStart UP My Screen LockSync is OUT of Range MessageNo Input is Detected Auto Search Option MenuONE Touch Auto OFFOption Menu Network Menu Ex. Case of IP Address = When your network enables the Dhcp functionNetwork Menu Screen Network Menu Maintenance LampCase of replacement by yourself LampAir ﬁlter Page Related messages Internal portion temperature is rising Related messagesRegarding the indicator lamps Regarding the indicator lamps These has not been properly ﬁxed Electrical power cord is not pluggedPower switch is not set to the on position Phenomenon Cases not involving a machine defect ReferencePhenomena that may easily be mistaken for machine defects RGB input SpeciﬁcationDigital RGB input Video input RGB output Communication portSpeciﬁcations Page Vesa Example of computer signalVesa Text Initial set signals Connection to the ports RGB in 1, B RGB in 2, C RGB OUTDVI -D CTS Audio in Ø3.5 stereo mini jack, J K Audio INL/R RCA jackRTS DC OUTRS-232C Communication Connecting the cableCommunications setting Using the projector default settings Reset Command Requesting projector status Get commandChanging the projector settings Set command Increasing the projector setting value Increment commandCRC Be EF FB FA Color Temp Gain G Progressive Color Space Mute OSD Bright Dukane Corporation Audio Visual Products