Delta Electronics RTU-DNET manual Basic Operation, IN0, IN1

DeviceNet Remote I/O Communication Module RTU-DNET

	OFF	When DeviceNet is off, the I/O data in
		the buffer area will be cleared.
IN0
	ON	When DeviceNet is off, the I/O data in
		the buffer area will be held.

IN1 Reserved

Note:

zPlease set up the function switch when the power is switched off. After the setup is completed, re-power RTU-DNET.

zWhen RTU-DNET is operating, changing the setting of the function switch will be invalid.

zUse slotted screwdriver to adjust the DIP switch carefully in case you scratch the switch.

2.7Extension Port

The extension port is used on connecting RTU-DNET to DVP Slim DI/DO extension units and special modules.

3 Basic Operation

3.1Connecting RTU-DNET to DVP Slim DI/DO Extension Unit

z Open the fixing clips on top and bottom of RTU-DNET. Meet the extension port of Slim DI/DO with RTU-DNET. z Press the fixing clips on top and bottm of Slim DI/DO and check if the connection is fine.

TE

TR U - ND

16SP	02DA
DVP-	DVP-

3.2Installing RTU-DNET and DVP Slim DI/DO on DIN Rail z Use 35mm DIN rail.

z Open the DIN rail clip on RTU-DNET and Slim DI/DO. Insert RTU-DNET and Slim DI/DO onto the DIN rail. z Clip up the DIN rail clips on RTU-DNET and Slim DI/DO to fix them on the DIN rail, as shown below.

TR U- ND TE

35mm DIN rail

16SP	02DA
DVP-	DVP-

DVP-PLC Application Manual 7