Onkyo SKC-960C, SKW-960, SKF-960F, SKB-960 Important Note Regarding Video Playback, Nent Video OUT

Page 104

Troubleshooting—Continued

The AV receiver contains a microcomputer for signal pro- cessing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this happens, unplug the power cord from the wall out- let, wait at least 5 seconds, and then plug it back in again.

Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by this unit’s malfunction. Before you record important data, make sure that the material will be recorded correctly.

Before disconnecting the power cord from the wall out- let, set the AV receiver to Standby.

Important Note Regarding Video Playback

The AV receiver can upscale component video, S-Video, and composite video sources for display on a TV that’s connected to the HDMI OUT. However, if the picture quality of the source is poor, upscaling may make the picture worse or disappear altogether.

In this case, try setting the HDMI Output Resolution set- ting to 480p or 720p (page 89). If that doesn’t improve the picture quality, try the following:

1.If the video source is connected to a component video input, connect your TV to the COMPO-

NENT VIDEO OUT.

If the video source is connected to an S-Video input, connect your TV to an S-Video output.

If the video source is connected to a composite video input, connect your TV to a composite video output.

2.On the main menu, select “1. Input Assign,” and then select “1. HDMI Input.” Select the relevant input selector, and assign it to “-----” (page 46).

3.On the main menu, select “1. Input Assign,” and then select “2. Component Video Input”

(page 47):

If the video source is connected to COMPONENT VIDEO IN 1, select the relevant input selector, and assign it to “IN1.”

If the video source is connected to COMPONENT VIDEO IN 2, select the relevant input selector, and assign it to “IN2.”

If the video source is connected to an S-Video or composite video input, select the relevant input selector, and assign it to “-----”.

104

Image 104

Contents HT-S9100THX Important Safety Instructions AvisPrecautions PowerPreventing Hearing Loss Caution Batteries and Heat Exposure WarningSpeaker Precautions PrecautionsPlacement Using Close to a TV or ComputerPackage Contents Contents Contents Features AmpliﬁerProcessing ConnectionsAutomatic speaker setup Input setup Input display Getting Started in Five Easy StepsGetting to Know the AV Receiver Front PanelGetting to Know the AV Receiver DisplayRear Panel Subwoofer PRE OUT Using the Cork Spacers for a More Stable Platform Speaker PackageRemote Controller Standby/On indicatorSubwoofer SKW-960 FrontRemote Controller Controlling the AV ReceiverInstalling the Batteries Using the Remote ControllerConnecting the Speakers Enjoying Home TheaterSpeaker Set a Main Room Speaker Set B Sub RoomSubwoofer Indicator OutputCenter speaker Connecting the Speakers Wall Mounting the SpeakersFront Speakers SKF-960F Surround SKM-960S and Surround Back Speakers SKB-960Connecting Speaker Set B not included Speaker Connection PrecautionsConnecting Speaker Set a Speaker Set a Speaker Set BConnecting Antennas Connecting the AM Loop AntennaConnecting the Indoor FM Antenna Attach the FM antenna, as shown American ModelConnecting Antennas Connecting an Outdoor FM AntennaConnecting an Outdoor AM Antenna Using a TV/FM Antenna SplitterConnecting Your Components About AV ConnectionsOptical Digital Jacks AV Connection Color CodingConnecting Your Components Connecting Audio and Video Signals to the AV ReceiverWhich Connections Should I Use? Audio Connection FormatsTV, projector, etc Video Signal Flow Chart DVD player, etcVideo Connection Formats Connecting a TV or Projector Video ConnectionAudio Connection HintConnecting a DVD player DVD playerHooking Up the Multichannel Input DigitalConnecting a VCR or DVR for Playback VCR or DVRConnecting a VCR or DVR for Recording Make the audio connection aConnect one or the other Inputs may need to be Assigned see Connecting Components with Hdmi About HdmiSupported Audio Formats About Copyright ProtectionMaking Hdmi Connections Video SignalsAudio Signals Connecting a Camcorder, Game Console, or Other Device Make the video connection a Make the audio connection aCamcorder Game console, etc Camcorder or consoleStep CD playerCD or turntable Phono preampConnecting a Cassette, CDR, MiniDisc, or DAT Recorder Cassette, CDR, MD, etcConnecting an RI Dock Not all iPod models output videoIf Your iPod Supports Video If Your iPod Doesn’t Support VideoConnecting Onkyo Components Connecting the Power CordAuto Power On/Standby Remote ControlDo the automatic speaker setup-this is essential Turning On the AV ReceiverTurning On and Standby Up and Running in a Few Easy StepsFirst Time Setup Automatic Speaker SetupUsing Audyssey 2EQ Measurement PositionsFirst Time Setup On the SKW-960 Subwoofer, setOutput Level control to Press EnterError Messages To Retry the Automatic Speaker Setup Changing the Speaker Settings ManuallyUsing a Powered Subwoofer Write ErrorHdmi Input Setup Component Video Input Setup Digital Input SetupMain menu appears onscreen Sure the appropriate external input isHdmi Input Setup on page 46, this input assign Changing the Input DisplayAutomatic Audio Input Selection Setup Select a listening mode and enjoy See Using the Listening Modes onPlaying Your AV Components Basic AV Receiver OperationSetting the Display Brightness Using the Sleep TimerCommon Functions Muting the AV ReceiverDisplaying Source Information 7Using HeadphonesCommon Functions Specifying the Digital Signal Format Press and hold the AV receiver’sDigital Input button for about SecondsListening to AM/FM Stations Tuning into AM/FM Radio StationsListening to the Radio Displaying AM/FM Radio Information Tuning into Stations by FrequencyListening to the Radio Selecting Presets Presetting AM/FM StationsDeleting Presets RDS Program Types PTY Using RDS European model onlyWhat is RDS? Finding Stations by Type PTY Displaying Radio Text RTListening to Trafﬁc News TP Using the Listening Modes Selecting with the Remote ControllerSelecting the Listening Modes Selecting on the AV ReceiverAnalog and PCM Sources Using the Listening ModesListening Modes Available for Each Source Format Game Dolby Digital and Dolby Digital Plus Sources MOVIE/TVUsing the Listening Modes DTS Sources DTSTHX TrueHD Sources Multichannel 2ch DTS-HD Sources THX DTS Express and DSD Sources Listening Mode DTS Express About the Listening Modes DTS-HD High Resolution Audio DTS-ES MatrixDTS Neo6 Neo6 CinemaOnkyo Original DSP Modes Recording from Different AV Sources RecordingRecording the Input Source Adjusting the Listening Modes Using the Audio Adjust SettingsMultiplex/Mono Settings PLIIx/Neo6 SettingsAdjusting the Listening Modes Dolby EX SettingTheater-Dimensional Setting LFE Level SettingsUsing the Audio Functions Tone ControlLate Night Function Re-EQ THXAudyssey Dynamic EQ Speaker LevelsMusic Optimizer SyncListening Mode Presets Advanced Setup Speaker SetupPress the Receiver button, followed by the Setup button Speaker ConﬁgurationAdvanced Setup Speaker DistancePink noise test tone is output by the front left speaker Buttons to select Equalizer SettingsSetup menu closes THX Audio Setup Surround Back SP Spacing SettingBGC Boundary Gain Compensation Setting Loudness PlusSource Setup IntelliVolumeOSD Setup Miscellaneous SetupVolume Setup Hardware Setup Remote ControlAnalog Multich Audio TV Out Lip SyncColor ControlThen press Enter Use the Left and Right Buttons to select Lock SetupButtons to select 8. Lock Setup Controlling Other Components Preprogrammed Remote Control CodesEntering Remote Control Codes Resetting the Remote Controller Remote Control Codes for Onkyo Components Connected viaResetting the Remote Mode Buttons Controlling Other ComponentsControlling a TV Controlling a DVD Player or DVD Recorder Play Mode button Controlling a VCR or PVRPrevious button Next buttonCancels functions or clears entered numbers Controlling a Satellite Receiver or Cable ReceiverDisc +/- button Controlling a CD Player, CD Recorder, or MD PlayerSearch button Controlling an RI Dock Controlling a Cassette Recorder Troubleshooting Troubleshooting Remote controller doesn’t work Sound changes when I connect my head- phonesThere’s no picture from a source connected to an Hdmi Can’t control other componentsImportant Note Regarding Video Playback Nent Video OUTSpeciﬁcations AV receiver HT-R960Powered Subwoofer SKW-960 SpeciﬁcationsSpeaker Package HTP-960 Front/Center Speaker SKF-960F/SKC-960CVideo Resolution Chart InputOnscreen Setup Menu Map Menu MapMain menu Submenu PagesMemo 110 111 Onkyo Europe Electronics GmbH Onkyo Europe UK Office