Onkyo SKM-960S, SKW-960, SKF-960F, SKC-960C Making Hdmi Connections, Video Signals, Audio Signals

Connecting Your Components—Continued

Making HDMI Connections

Step 1: Use HDMI cables to connect the AV receiver’s HDMI jacks to your HDMI-compatible DVD player, TV, projector, and so on.

Step 2: Assign each HDMI IN to an input selector in the HDMI Input Setup (see page 46).

■Video Signals

Digital video signals received by the HDMI IN jacks are normally output by the HDMI OUT for display on your TV. Composite video, S-Video, and component video sources are upconverted and, depending on the resolution of your TV, upscaled for output by the HDMI OUT. See “Video Connection Formats” on page 27 and the “Video Resolution Chart” on page 107 for more information.

■Audio Signals

Digital audio signals received by the HDMI IN jacks are output by the speakers and headphones connected to the AV receiver. Normally, they are not output by the HDMI OUT.

Hint!

To listen to audio received by the HDMI IN jacks through your TV’s speakers, set the Audio TV Out setting to On (see page 90), and set your DVD player’s HDMI audio output setting to PCM.

HDMI	HDMI
OUT	IN

DVD player

		IN 1	(DVD)		OUT
			HDMI
			ASSIGNABLE
IN 4	IN 3 (CBL/SAT)	IN 2	(VCR/DVR)	IN 1 (DVD)	OUT

TV

DIGITAL IN COMPONENT VIDEO

Y

1

(DVD)

COAXIAL

CB/ PB

2

(CBL/SAT)

CBL/SAT VCR/DVR

V

MONITOR

DVD OUT

V

AM

ANTENNA

		CR/ PR
1
(VCR/DVR)
OPTICAL	IN 2(CBL/SAT) IN 1(DVD)	OUT
2	ASSIGNABLE

S

IN OUT IN

S

IN

FM 75

(CD)	IN	OUT	IN
ASSIGNABLE
	L
	R
REMOTE
CONTROL
	CD		TAPE

IN OUT IN

L

R

CBL/SAT VCR/DVR

FRONT SURR CENTER SURR BACK

L

R

SUB

WOOFER

DVD

Notes:

•The HDMI video stream is compatible with DVI (Digital Visual Interface), so TVs and displays with a DVI input can be connected by using an HDMI-to-DVI adapter cable. (Note that DVI connections only carry video, so you’ll need to make a separate connection for audio.) However, reliable operation with such an adapter is not guaranteed. In addition, video signals from a PC are not supported.

•To listen to an HDMI source component through the AV receiver, you must configure your system so that video from the HDMI source component can be displayed on your TV (i.e., on your TV, select the HDMI input that’s connected to the AV receiver’s HDMI OUT). This is necessary because a component identification check has to be performed on your TV before an HDMI source component can output any signals. If your TV is off or set to a different input source, the AV receiver may produce no sound or the sound may be distorted.

•The HDMI audio signal (sampling rate, bit length, etc.) may be restricted by the connected source component. If the picture is poor or there’s no sound from a component connected via HDMI, check its setup. Refer to the connected component’s instruction manual for details.

35