Onkyo SKB-960, SKW-960 Common Functions, Setting the Display Brightness, Muting the AV Receiver

Page 51

Common Functions

This section explains functions that can be used with any input source.

DISPLAY

Press

[RECEIVER] MUTING ﬁrst

DIMMER

SLEEP

DISPLAY

MASTER VOLUME

ON/STANDBY

TUNING

PRESET

STANDBY

THX

MULTI CH

DVD

VCR/DVR

CBL/SAT

AUX

TAPE

TUNER

CD

SETUP

RETURN

AUX INPUT

PHONES

SETUP MIC

VIDEO

L

AUDIO

R

A

SPEAKERS

B

TONE

MOVIE/TV

MUSIC

GAME

DISPLAY

DIGITAL INPUT

DIMMER

MEMORY TUNING MODE

LISTENING MODE

AV RECEIVER

HT-R960

PHONESDIMMER

Setting the Display Brightness

You can adjust the brightness of the display.

Muting the AV Receiver

You can temporarily mute the output of the AV receiver.

Press the [RECEIVER] REMOTE MODE button, and then press the remote controller’s [MUTING] button.

The output is muted and the MUTING indicator ﬂashes on the display.

To unmute the AV receiver, press the remote control- ler’s [MUTING] button again, or adjust the volume. The output is unmuted and the MUTING indicator goes off. Muting is cancelled when the AV receiver is set to Standby.

Using the Sleep Timer

With the sleep timer, you can set the AV receiver so that it turns off automatically after a speciﬁed period.

Press the [RECEIVER] REMOTE MODE button, and then press the remote controller’s [SLEEP] but- ton repeatedly to select the required sleep time.

You can set the sleep time from 90 to 10 minutes in 10 minute steps.

The SLEEP indicator appears on the display when the sleep timer has been set, as shown. The speciﬁed sleep time appears on the display for about 5 sec- onds, then the previous display reap- pears.

SLEEP indicator

Remote

controller

AV receiver

DIMMER

Press the [RECEIVER] REMOTE MODE button, and then press the remote controller’s [DIMMER] button repeatedly to select: dim, dimmer, or normal brightness.

You can also use the AV receiver’s [DIMMER] button (not the European model).

To cancel the sleep timer, press the [SLEEP] button repeatedly until the SLEEP indicator disappears.

To check the remaining sleep time, press the [SLEEP] button. Note that if you press the [SLEEP] button while the sleep time is being displayed, you’ll shorten the sleep time by 10 minutes.

51

Image 51

Contents HT-S9100THX Avis Important Safety InstructionsBatteries and Heat Exposure Warning PrecautionsPower Preventing Hearing Loss CautionUsing Close to a TV or Computer Speaker PrecautionsPrecautions PlacementPackage Contents Contents Contents Connections FeaturesAmpliﬁer ProcessingGetting Started in Five Easy Steps Automatic speaker setup Input setup Input displayFront Panel Getting to Know the AV ReceiverDisplay Getting to Know the AV ReceiverRear Panel Subwoofer PRE OUT Speaker Package Using the Cork Spacers for a More Stable PlatformFront Remote ControllerStandby/On indicator Subwoofer SKW-960Controlling the AV Receiver Remote ControllerUsing the Remote Controller Installing the BatteriesSpeaker Set B Sub Room Connecting the SpeakersEnjoying Home Theater Speaker Set a Main RoomIndicator Output Center speakerSubwoofer Surround SKM-960S and Surround Back Speakers SKB-960 Connecting the SpeakersWall Mounting the Speakers Front Speakers SKF-960FSpeaker Connection Precautions Connecting Speaker Set aConnecting Speaker Set B not included Speaker Set B Speaker Set aAttach the FM antenna, as shown American Model Connecting AntennasConnecting the AM Loop Antenna Connecting the Indoor FM AntennaUsing a TV/FM Antenna Splitter Connecting AntennasConnecting an Outdoor FM Antenna Connecting an Outdoor AM AntennaAV Connection Color Coding Connecting Your ComponentsAbout AV Connections Optical Digital JacksAudio Connection Formats Connecting Your ComponentsConnecting Audio and Video Signals to the AV Receiver Which Connections Should I Use?Video Signal Flow Chart DVD player, etc Video Connection FormatsTV, projector, etc Hint Connecting a TV or ProjectorVideo Connection Audio ConnectionDVD player Connecting a DVD playerDigital Hooking Up the Multichannel InputVCR or DVR Connecting a VCR or DVR for PlaybackMake the audio connection a Connecting a VCR or DVR for RecordingConnect one or the other Inputs may need to be Assigned see About Copyright Protection Connecting Components with HdmiAbout Hdmi Supported Audio FormatsVideo Signals Audio SignalsMaking Hdmi Connections Camcorder or console Connecting a Camcorder, Game Console, or Other DeviceMake the video connection a Make the audio connection a Camcorder Game console, etcPhono preamp StepCD player CD or turntableCassette, CDR, MD, etc Connecting a Cassette, CDR, MiniDisc, or DAT RecorderIf Your iPod Doesn’t Support Video Connecting an RI DockNot all iPod models output video If Your iPod Supports VideoRemote Control Connecting Onkyo ComponentsConnecting the Power Cord Auto Power On/StandbyUp and Running in a Few Easy Steps Do the automatic speaker setup-this is essentialTurning On the AV Receiver Turning On and StandbyMeasurement Positions First Time SetupAutomatic Speaker Setup Using Audyssey 2EQPress Enter First Time SetupOn the SKW-960 Subwoofer, set Output Level control toError Messages Write Error To Retry the Automatic Speaker SetupChanging the Speaker Settings Manually Using a Powered SubwooferHdmi Input Setup Sure the appropriate external input is Component Video Input SetupDigital Input Setup Main menu appears onscreenChanging the Input Display Hdmi Input Setup on page 46, this input assignAutomatic Audio Input Selection Setup Basic AV Receiver Operation Select a listening mode and enjoySee Using the Listening Modes on Playing Your AV ComponentsMuting the AV Receiver Setting the Display BrightnessUsing the Sleep Timer Common Functions7Using Headphones Common FunctionsDisplaying Source Information Seconds Specifying the Digital Signal FormatPress and hold the AV receiver’s Digital Input button for aboutTuning into AM/FM Radio Stations Listening to the RadioListening to AM/FM Stations Tuning into Stations by Frequency Listening to the RadioDisplaying AM/FM Radio Information Presetting AM/FM Stations Deleting PresetsSelecting Presets Using RDS European model only What is RDS?RDS Program Types PTY Displaying Radio Text RT Listening to Trafﬁc News TPFinding Stations by Type PTY Selecting on the AV Receiver Using the Listening ModesSelecting with the Remote Controller Selecting the Listening ModesUsing the Listening Modes Listening Modes Available for Each Source FormatAnalog and PCM Sources Game MOVIE/TV Dolby Digital and Dolby Digital Plus SourcesUsing the Listening Modes DTS DTS SourcesTHX TrueHD Sources Multichannel 2ch DTS-HD Sources THX DTS Express and DSD Sources Listening Mode DTS Express About the Listening Modes Neo6 Cinema DTS-HD High Resolution AudioDTS-ES Matrix DTS Neo6Onkyo Original DSP Modes Recording Recording the Input SourceRecording from Different AV Sources PLIIx/Neo6 Settings Adjusting the Listening ModesUsing the Audio Adjust Settings Multiplex/Mono SettingsLFE Level Settings Adjusting the Listening ModesDolby EX Setting Theater-Dimensional SettingRe-EQ THX Using the Audio FunctionsTone Control Late Night FunctionSync Audyssey Dynamic EQSpeaker Levels Music OptimizerListening Mode Presets Speaker Conﬁguration Advanced SetupSpeaker Setup Press the Receiver button, followed by the Setup buttonSpeaker Distance Advanced SetupPink noise test tone is output by the front left speaker Equalizer Settings Setup menu closesButtons to select Loudness Plus THX Audio SetupSurround Back SP Spacing Setting BGC Boundary Gain Compensation SettingIntelliVolume Source SetupMiscellaneous Setup Volume SetupOSD Setup Remote Control Hardware SetupAnalog Multich Control Audio TV OutLip Sync ColorLock Setup Buttons to select 8. Lock SetupThen press Enter Use the Left and Right Buttons to select Preprogrammed Remote Control Codes Entering Remote Control CodesControlling Other Components Controlling Other Components Resetting the Remote ControllerRemote Control Codes for Onkyo Components Connected via Resetting the Remote Mode ButtonsControlling a TV Controlling a DVD Player or DVD Recorder Next button Play Mode buttonControlling a VCR or PVR Previous buttonControlling a Satellite Receiver or Cable Receiver Cancels functions or clears entered numbersControlling a CD Player, CD Recorder, or MD Player Search buttonDisc +/- button Controlling an RI Dock Controlling a Cassette Recorder Troubleshooting Troubleshooting Can’t control other components Remote controller doesn’t workSound changes when I connect my head- phones There’s no picture from a source connected to an HdmiNent Video OUT Important Note Regarding Video PlaybackAV receiver HT-R960 SpeciﬁcationsFront/Center Speaker SKF-960F/SKC-960C Powered Subwoofer SKW-960Speciﬁcations Speaker Package HTP-960Input Video Resolution ChartSubmenu Pages Onscreen Setup Menu MapMenu Map Main menuMemo 110 111 Onkyo Europe UK Office Onkyo Europe Electronics GmbH