Onkyo TX-NR5009 instruction manual Source Setup, Sound Program Edit, Audyssey

Sound Program Edit

■Sound Program

`Stereo Source 1, Stereo Source 2, Stereo Source 3, Multich Source 1, Multich Source 2, Multich

Source 3

When playing back different content types on the same source, or when listening to a single content type on different sources, you can pre-register the settings that best suit each content in “Sound Program”. The registered settings can then be called up and modified in one set. Use “Sound Program Edit” to register and modify a combination of settings.

Tip

•To select the registered settings, see “Sound Program” (➔ page 69).

■Listening Mode

You can assign a default listening mode that will be selected automatically when you select the sound program.

The “Last Valid” option means that the listening mode selected last will be used.

The “Straight Decode” option means that straight decoding listening mode (Dolby Digital, DTS, etc.) is selected.

■Subwoofer

`No, Yes

You can choose whether or not to use the subwoofer with the sound program.

■Music Optimizer*1

`Off, On

See “Music Optimizer” (➔ page 70).

■Equalizer*1

`Off

`Manual:

The manual setting in “Equalizer Settings” (➔ page 54) is applied.

■Audyssey*1

`Off, Movie, Music See “Audyssey”.

■Dynamic EQ*1*2

`Off, On

See “Dynamic EQ” (➔ page 59).

■Dynamic Volume*1*2

`Off, Light, Medium, Heavy

See “Dynamic Volume” (➔ page 59).

■Dolby Volume*1

`Off, On

See “Dolby Volume” (➔ page 56).

Note

•“Listening Mode” is only available when the input signal matches the setting of “Sound Program”.

•You cannot select the “Subwoofer” setting if you set to “No” in the “Speaker Configuration”.

•“Music Optimizer” is only available when “Stereo Source 1”, “Stereo Source 2” or “Stereo Source 3” is selected.

•When “Audyssey Quick Start” has been used for measurement, the “Audyssey”setting cannot be selected.

*1 This setting cannot be used when the “Listening Mode” setting is set to “Pure Audio” or “Direct”.

*2 To enable this setting, you must first perform the Room Correction and Speaker Setup.

Source Setup

Items can be set individually for each input selector.

Preparation

Press the input selector buttons to select an input source.

Main menu Source Setup

Audyssey

The tone for each speaker is set automatically by Audyssey MultEQ® XT32 Room Correction and Speaker Setup. To enable the following settings, you must first perform the Room Correction and Speaker Setup (➔ page 33).

These technologies cannot be used when:

•a pair of headphones is connected, or

•Speakers B is being used, or

•either Pure Audio or Direct listening mode is selected.

■Audyssey

`Off

`Movie:

Select this setting for movie material.

The Audyssey indicator lights.

`Music:

Select this setting for music material.

The Audyssey indicator lights.

Note

•If the “Audyssey” setting is set to “Off”, the “Equalizer” settings are applied (➔ page 54).

•When “Audyssey Quick Start” has been used for measurement, the “Audyssey”setting cannot be selected.

•Audyssey equalizing does not work with DSD sources.

En

58