Onkyo TX-NR5009 instruction manual Audyssey DSX, Theater-Dimensional, LFE Level, Direct, Dsd

DTS

■Neo:X Music Center Image

`0 to 2 to 5

The DTS Neo:X Music listening mode creates 9-channel surround sound from 2-channel stereo sources. With this setting, you can specify by how much the front left and right channel output is attenuated in order to create the center channel.

Changing the value from “0” to “5” will spread the sound of the center channel to left and right (outwards).

Audyssey DSX™

■Soundstage

`–3dB to Reference to +3dB

With this setting, you can adjust the sound stage when using Audyssey DSX.

Note

•This listening mode can be selected only when all the following conditions are satisfied:

–The center speaker is connected.

–The front high and front wide speakers are connected.

•The “Soundstage” setting cannot be adjusted while Speakers B is selected.

Theater-Dimensional

■Listening Angle

`Wide:

Select if the listening angle is greater than 30 degrees.

`Narrow:

Select if the listening angle is less than 30 degrees. With this setting, you can optimize the Theater- Dimensional listening mode by specifying the angle of the front left and right speakers relative to the listening position. Ideally, the front left and right speakers should be equidistant from the listening position and at an angle close to one of the two available settings.

Front left speaker	Front right speaker
	Listening angle: 30°

LFE Level

■Dolby Digital*1, DTS*2, Multich PCM, Dolby TrueHD, DTS-HD Master Audio, DSD*3

`–QdB,–20dB,–10dB, or 0dB

With these settings, you can set the level of the LFE (Low Frequency Effects) channel individually for each input sources.

If you find that low-frequency effects are too loud when using one of these sources, change the setting to –20 dB or

–QdB.

*1 Dolby Digital and Dolby Digital Plus sources

*2 DTS and DTS-HD High Resolution sources

*3 DSD (Super Audio CD) sources

Direct

■Analog Subwoofer

`Off:

Analog audio signals (bass signals) are not output.

`On:

Analog audio signals (bass signals) are output. This setting determines whether or not analog audio signals (bass signals) are output from front speakers when the Pure Audio or Direct listening mode is selected.

Note

•If the “Subwoofer” setting is set to “No” (➔ page 52), this setting cannot be selected.

■DSD

DAC Direct

`Off:

DSD signals are processed by the DSP.

`On:

DSD signals are not processed by the DSP.

This setting determines whether or not DSD (Super Audio CD) audio signals are passed through the DSP for A/V Sync, delay, etc., processing when the Pure Audio or Direct listening mode is selected.

Note

•Once you have selected “Yes”, only DAC Direct will be available for selection. “DSD Direct” will appear on the display.

En

57