Onkyo TX-NR5009 Advanced Setup, On-screen Setup Menus, Common Procedures in Setup Menu

Advanced Setup

The on-screen menus appear only on a TV that is connected to the HDMI OUT MAIN. If your TV is connected to other video outputs, use the AV receiver’s display when changing settings.

This section describes the procedure for using the remote controller unless otherwise specified.

On-screen Setup Menus

MENU

a1. Input/Output Assign b 2. Speaker Setup

c 3. Audio Adjust d 4. Source Setup

e 5. Listening Mode Preset f 6. Miscellaneous

g 7. Hardware Setup

h 8. Remote Controller Setup i 9. Lock Setup

a Input/Output Assign		f Miscellaneous
(➔ page 48)		(➔ page 64)
	1. Input/Output Assign		6. Miscellaneous
1.	Monitor Out	1.	Volume Setup
2.	HDMI Input	2.	OSD Setup

3.Component Video Input

4.Digital Audio Input

5.Analog Audio Input

b Speaker Setup			g Hardware Setup
	(➔ page 51)		(➔ page 65)
		2. Speaker Setup		7. Hardware Setup
1.		Speaker Settings	1.	Remote ID
2.		Speaker Configuration	2.	Multi Zone
3.		Speaker Distance	3.	Tuner
4.		Level Calibration	4.	HDMI
5.		Equalizer Settings	5.	Auto Standby
6.		THX Audio Setup	6.	Network
			7.	Firmware Update
c Audio Adjust			h Remote Controller
	(➔ page 55)		Setup (➔ page 79)
				8. Remote Controller Setup
		3. Audio Adjust
1.		Multiplex/Mono	1.	Remote Mode Setup
2.		Dolby	2.	Activities Setup

3.DTS

4.Audyssey DSX

5.Theater-Dimensional

6.LFE Level

7.Direct

8.Sound Program Edit

d Source Setup	i Lock Setup
(➔ page 58)	(➔ page 69)

Common Procedures in Setup Menu

RECEIVER

ENTER

q/w/e/r

SETUP RETURN

The on-screen setup menus appear on the connected TV and provide a convenient way to change the AV receiver’s various settings. Settings are organized into 9 categories on the main menu.

Carry out the settings by using the on-screen display.

1 Press RECEIVER followed by SETUP. Tip

•If the main menu doesn’t appear, make sure the appropriate external input is selected on your TV.

2	Use q/wto select a menu, and then press ENTER.
3	Use q/wto select a target, and then press ENTER.
4	Use q/wto select an option, and use e/rto change
	the setting.

Press SETUP to close the menu.

Press RETURN to return to the previous menu.

Note

•This procedure can also be performed on the AV receiver by using SETUP, the arrow buttons, and ENTER.

•During Audyssey MultEQ® XT32 Room Correction and Speaker Setup, messages, etc., that are displayed on the TV screen will appear in the Display.

Explanatory Notes

a Main Menu Speaker Setup

4.Source Setup

1.Audyssey

2.IntelliVolume

3.A/V Sync

4.Name Edit

5.Picture Adjust

6.Audio Selector

eListening Mode Preset (➔ page 64)

5.Listening Mode Preset

1.BD/DVD

2.VCR/DVR

3.CBL/SAT

4.GAME

5.PC

6.AUX

9.Lock Setup

Setup

b■ Subwoofer

c `1ch:

Audio signal is outputted from SW1 jack only.

`2ch:

Audio signal is outputted from SW1 and

SW2 jacks.

aMenu selection

bSetting target

cSetting options (default setting underlined)

En

47