11 
DISASSEMBLY INSTRUCTIONS
<"Terminal with locking mechanism" Detaching points>
The terminal which has the locking mechanism can be detached as shown below. There are two types ( Refer to (1) and (2)) of the terminal with locking mechanism. The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
1Slide the sleeve.
2Pull the terminal while
Locking lever 
pushing the locking lever.
(2)The terminal with this connector has the locking mechanism.
1Hold the sleeve, and pull out the terminal slowly.
Connector
MUZ-GB50VA
OUTDOOR UNIT
| OPERATING PROCEDURE |
| PHOTOS | |
1. Removing the cabinet | Photo 1 | Screw of the top panel | ||
(1) | Remove the screws of the service panel. | |||
| ||||
|
| |||
(2) | Remove the screws of the top panel. |
|
| |
(3) | Remove the screw of the valve cover. |
|
| |
(4) | Remove the service panel. |
|
| |
(5) | Remove the top panel. |
|
| |
(6)Remove the valve cover.
(7)Remove the screws of the cabinet.
(8) | Remove the cabinet. | Screws | |
of the | |||
(9) | Remove the screws of the back panel. | ||
cabinet | |||
(10) Remove the back panel. | |||
| |||
Photo 3 | Screws of the cabinet | |
Photo 2 | ||
Screw of the motor support | ||
| Screw of the service panel |
| Screws | |
| of the | |
Screws | top | |
panel | ||
of the | ||
| ||
back | Screws | |
panel | ||
of the | ||
| ||
| cabinet | |
| Screw | |
| of the | |
| valve | |
| cover | |
| Set screws of the back panel |
34