Nokia DNT2Mi-fp Maintenance, Getting general information, S65692.01 A0 Serial number 4H0415

Page 33

Maintenance

7 Maintenance

This chapter describes what general information and statistics you can get on the equipment to be monitored. It also deals with possible alarms and faults. You can access all this information using Q1 menus. The menus are described in figure 20 and onwards.

7.1Getting general information

The Identifications menu, branch 4 on the Q1 main menu, gives the name and type of the unit to be monitored, the codes and versions of HW unit and program to be used and some installation information.

Identifications

Equipment type:

DNT2Mi-fp G.704 2w (T65690)

Equipment name:

DNT2Mi-fp

Installation date

First:

Last:

Installed by

HW:

E65691.01

ASW:

S65692.01 A0

Serial number: 4H0415

Figure 17. Example of general information

DN0445814	© Nokia Corporation	33 (60)
Issue 2-0 en	Nokia Proprietary and Confidential

Image 33

Contents DNT2Mi-fp Data Network Terminal Product versions Product codeContents Page Product collection and disposal within the European Union Document Date CommentPage About this document Page Introduction to DNT2Mi-fp PDHLocal Network ExchangeDNT2Mi-fp BTS Shdsl Power LED Alarm LEDFront view Page Rear panel Wall mountingFastener Power supply Line interfacePin modular jack, RJ-11 DSL Line Strapping instruction for Power Supply Selection of Power Supply option is done by strappingRemote Power Supply default 48V DC SupplyExternal AC/DC converter Supply Removal instruction Remote power feed through line 48VDC 110/230 V AC Converter Earthing bar Mm2 wireTerminal interface 704/2M Pin modular jack Pin Data interface RJ-45Symmetrical G.704/2M interface Page Management Use of signal 108 when using MsteDIP Switch LMI Interface type selection Code Name Connector type Length107 HiZ Tx b OUT 108 109 Tx a OUT 103 Rx b 104 Q1 management bus DIP-switchPage Commissioning Automatic power-up testTiming source ManagementQ1 transmission speed Q1 6,1,1 Q1 address Q1 6,1,2Line settings Power backoff Q1 6,3,6Line interface Q1 6,3,3 Protection settings Port settingsAfter the tests MeasurementsPage Maintenance Getting general informationS65692.01 A0 Serial number 4H0415 DNT2Mi AS Line No incoming signal Monitoring alarmsDNT2Mi-fp Code Severity Q1 messageTesting SB 1, PortSB 2, Line Q1 management Automatic controll Port Interface LinePort Interface Line Interface Measurements via Q1 Checking measurements and statisticsMonitoring a line DNT2Mi-fp statisticsStatistics values via Q1 Information Abbreviation Description And/or ratioSystem counters Q1 8,3 DNT2Mi-fp dimensions Technical specificationsEnvironmental and mechanical Line interface in accordance with ITU-T G.991.2Data lead time Data interface= 3 to 32 192 kbit/ to 2048 kbit/s Data lead-time ACL2i to DNT2Mi-fpDNT2Mi-fp power supply Power consumptionPower supply external AC/DC converter DC power supply SafetyRemote power supply Mean time between failure MtbfPage Service settings Factory settingsLine interface settings Data interface settings E1Alarm limits Identifications Controls Settings Measurements Statistics Fault displayUser priviliges GeneralMain Q1 menu structure Identifications menu 2,1 Controls menu 2,1 Settings menu structureSettings menu structure 100 3,13,1,2 3,1,4Give filling value 0 or 2,1..5Measurements menu structure Statistics menu structure 3,1..2,0 10,1 DNT-fp privileges10,3 10,4