Nokia DNT2Mi-fp user manual Settings menu structure, 2,1

Page 52

DNT2Mi-fp Data Network Terminal User manual

The factory settings are marked within brackets.

6

DNT-fp settings:

0Display

1Service options

2Timing source (Line)

3Line settings

4Port settings

7 Load factory settings

6,1

Service options:

0Display

1Q1 Speed (4800)

2Q1 Address (2)

3Q1 via line (On)

7 Test time out limit (10)

12 Temperature alarm limit (75C)

13 Temperature alarm severity(No alarm)

6,1,1

Q1 speed:

0 Display Set speed 600 ...9600

6,1,2

Q1 address:

0 Display

1 Modify

6,2	6,1,3
6,3	6,1,7
6,4	6,1,12
6,7	6,1,13

6,1,2,1

Give new address: 0 to 4094

Figure 26. Settings menu structure

52 (60)	© Nokia Corporation	DN0445814
	Nokia Proprietary and Confidential	Issue 2-0 en

Image 52

Contents DNT2Mi-fp Data Network Terminal Product code Product versionsContents Page Document Date Comment Product collection and disposal within the European UnionPage About this document Page PDHLocal Network Exchange Introduction to DNT2Mi-fpDNT2Mi-fp BTS Shdsl Alarm LED Power LEDFront view Page Wall mounting Rear panelFastener Line interface Power supplyPin modular jack, RJ-11 DSL Line Selection of Power Supply option is done by strapping Strapping instruction for Power Supply48V DC Supply Remote Power Supply defaultExternal AC/DC converter Supply Removal instruction Remote power feed through line 48VDC Converter Earthing bar Mm2 wire 110/230 V AC704/2M Pin modular jack Pin Data interface RJ-45 Terminal interfaceSymmetrical G.704/2M interface Page Use of signal 108 when using Mste ManagementCode Name Connector type Length DIP Switch LMI Interface type selection107 HiZ Tx b OUT 108 109 Tx a OUT 103 Rx b 104 DIP-switch Q1 management busPage Automatic power-up test CommissioningManagement Timing sourceQ1 transmission speed Q1 6,1,1 Q1 address Q1 6,1,2Power backoff Q1 6,3,6 Line settingsLine interface Q1 6,3,3 Port settings Protection settingsMeasurements After the testsPage Getting general information MaintenanceS65692.01 A0 Serial number 4H0415 Monitoring alarms DNT2Mi AS Line No incoming signalDNT2Mi-fp Code Severity Q1 messageSB 1, Port TestingSB 2, Line Port Interface Line Q1 management Automatic controllPort Interface Line Interface Checking measurements and statistics Measurements via Q1Monitoring a line DNT2Mi-fp statisticsInformation Abbreviation Description And/or ratio Statistics values via Q1System counters Q1 8,3 Technical specifications DNT2Mi-fp dimensionsEnvironmental and mechanical Line interface in accordance with ITU-T G.991.2Data interface Data lead timeData lead-time ACL2i to DNT2Mi-fp = 3 to 32 192 kbit/ to 2048 kbit/sPower consumption DNT2Mi-fp power supplyPower supply external AC/DC converter Safety DC power supplyRemote power supply Mean time between failure MtbfPage Factory settings Service settingsLine interface settings Data interface settings E1Alarm limits Fault display Identifications Controls Settings Measurements StatisticsUser priviliges GeneralMain Q1 menu structure Identifications menu 2,1 Controls menu Settings menu structure 2,1Settings menu structure 3,1 1003,1,2 3,1,42,1..5 Give filling value 0 orMeasurements menu structure Statistics menu structure 3,1..2,0 DNT-fp privileges 10,110,3 10,4