Nokia DNT2Mi-fp user manual Line interface, Power supply, Pin modular jack, RJ-11 DSL Line

Page 14

DNT2Mi-fp Data Network Terminal User manual

4.1Line interface

6-pin modular jack, RJ-11

DSL Line

1 - 6

Pin Line interface

1.Line 1a

2.Line 1b

3.Not connected

4.Not connected

5.Line 2a (not in use in 2-w mode) *)

6.Line 2b (not in use in 2-w mode) *)

*) not connected in T65690.01

Figure 6. Line interfaces of DNT2Mi-fp

4.2Power supply

DNT2Mi-fp can be fed with either, 48VDC or remotely via ACL2i through the line. It is also possible to use a AC to DC converter (110/230VAC to 48VDC) to feed power to the DNT2Mi-fp.

14 (60)	© Nokia Corporation	DN0445814
	Nokia Proprietary and Confidential	Issue 2-0 en

Image 14

Contents DNT2Mi-fp Data Network Terminal Product code Product versionsContents Page Document Date Comment Product collection and disposal within the European UnionPage About this document Page DNT2Mi-fp Introduction to DNT2Mi-fpPDHLocal Network Exchange BTS Shdsl Front view Power LEDAlarm LED Page Fastener Rear panelWall mounting Pin modular jack, RJ-11 DSL Line Power supplyLine interface Selection of Power Supply option is done by strapping Strapping instruction for Power SupplyExternal AC/DC converter Supply Remote Power Supply default48V DC Supply Removal instruction Remote power feed through line 48VDC Converter Earthing bar Mm2 wire 110/230 V ACSymmetrical G.704/2M interface Terminal interface704/2M Pin modular jack Pin Data interface RJ-45 Page Use of signal 108 when using Mste Management107 HiZ Tx b OUT 108 109 Tx a OUT 103 Rx b 104 DIP Switch LMI Interface type selectionCode Name Connector type Length DIP-switch Q1 management busPage Automatic power-up test CommissioningQ1 transmission speed Q1 6,1,1 ManagementTiming source Q1 address Q1 6,1,2Line interface Q1 6,3,3 Line settingsPower backoff Q1 6,3,6 Port settings Protection settingsMeasurements After the testsPage S65692.01 A0 Serial number 4H0415 MaintenanceGetting general information DNT2Mi-fp Monitoring alarmsDNT2Mi AS Line No incoming signal Code Severity Q1 messageSB 2, Line TestingSB 1, Port Port Interface Line Interface Q1 management Automatic controllPort Interface Line Monitoring a line Checking measurements and statisticsMeasurements via Q1 DNT2Mi-fp statisticsSystem counters Q1 8,3 Statistics values via Q1Information Abbreviation Description And/or ratio Environmental and mechanical Technical specificationsDNT2Mi-fp dimensions Line interface in accordance with ITU-T G.991.2Data interface Data lead timeData lead-time ACL2i to DNT2Mi-fp = 3 to 32 192 kbit/ to 2048 kbit/sPower supply external AC/DC converter DNT2Mi-fp power supplyPower consumption Remote power supply SafetyDC power supply Mean time between failure MtbfPage Line interface settings Factory settingsService settings Data interface settings E1Alarm limits User priviliges Fault displayIdentifications Controls Settings Measurements Statistics GeneralMain Q1 menu structure Identifications menu 2,1 Controls menu Settings menu structure 2,1Settings menu structure 3,1,2 3,1100 3,1,42,1..5 Give filling value 0 orMeasurements menu structure Statistics menu structure 3,1..2,0 10,3 DNT-fp privileges10,1 10,4