Planar C3012T, C3013T user manual Back Housing, Inside

Page 15

Back Housing

Twelve T25 Torx screws

Four holes for standard

Planar mounting options (10⁄32)

Three T15 Torx screws

Figure 6 — Remove the back housing to gain access to the unit.

Inside

ISA 16-bit 1⁄2 Card

Expansion Slot

Battery

(Rayovac BR2335 or equivalent)

Standoffs

(DO NOT REMOVE)

2.5" Hard Disk

Fuse (F1), 10.0A Schurter 001.1014 or (F5), 10.0A Bussman GDA-10A on newer units

Fuse (F2), 2.0A Schurter

		3402.0012
	T-Bar	Multimedia
	(DO NOT REMOVE)	Multimedia
	(DO NOT REMOVE)	Speakers
		Speakers

SO DIMM

DRAM sockets

Standoffs

(DO NOT REMOVE)

EPM-1 Module with

Processor and BIOS

Figure 7

4Planar Clean Screen PC User’s Manual

Image 15

Contents User’s Manual Integrated Computer with LCD Color Display USER’S ManualIi Planar Clean Screen PC User’s Manual Commencement of Warranty Duration of WarrantyFederal Communications Commission FCC Requirements Technical Assistance Place of Repair or ReplacementLimitation of Warranty InstallationTable of Contents Vi Planar Clean Screen PC User’s Manual Reference Guide ViiWhat if I’m missing something? Before You BeginWhat’s in the box? What’s in this manual?Clean Screen Mounts and Accessories Safety InstructionsConnections Bottom Front PanelSetup Chapter One The Installation ExpressChapter Two The Clean Screen PC Clean Screen FactsWelcome Connections Bottom Inside Back HousingChapter Two The Clean Screen PC Removing the Back Housing Chapter Three Hardware Installation and ReplacementDo not remove the T-Bar or standoffs Installing an ISA Adapter CardInstalling Memory To install a SO Dimm moduleTo remove an SO Dimm module Installing the new hard disk Replacing the Hard Disk DriveRemoving the existing hard disk Flash memory. See Chapter Five Bios Setup Replacing the BatteryReplacing the Fuses Mounting the Clean Screen Floppy Drive Connector Chapter Four System SetupConnecting the Keyboard Connecting PeripheralsPowering Up the Clean Screen PC Power SupplyPower Cord Selection Headphones or External SpeakersFront Panel Controls Setup F2Push-Button Volume Control Driver OverviewChapter Five Bios Setup Entering the Bios Setup ProgramSetup Screens Main Menu Memory Shadow Sub-Menu Boot Sequence Sub-MenuKeyboard Features Sub-Menu Memory Cache Sub-MenuSetup Prompt Boot Sequence Sub-Menu under Main MenuBoot Delay Boot SequenceSummary Screen Floppy CheckAdvanced Menu Destination Address Bios ExtensionsBios Extension Offset in FBD Bios Extension SizeDiskette Controller LPT ModeIntegrated Peripherals Sub-Menu LPT PortTouch Panel Base Address Touch Panel IRQLocal Bus IDE Adapter Suspend Timeout Power MenuPower Savings Standby TimeoutStandby Break Events Fixed Disk TimeoutStandby Timer Reset Events KeyboardStandby Wakeup Events Exit Menu Restore Condition Clear Over Temperature ErrorAppendix C Approved cleaning solutions include Chapter Six Care and CleaningMaintenance Tips Cleaning TipsAppendix a Product Specifications Floppy Disk Drive Port Thermostatic Switch/Temperature SensorExternal Serial Ports Printer PortEnvironmental Specifications North America EuropeanDescription Pin Range CPU address Region Cached Appendix B Programming InterfaceMemory Map Assigned and Available IRQsDMAs Address ListAddress Device Appendix C Troubleshooting Troubleshooting ProcedureAnti-Virus Alert Causes Boot FailuresProblems After the System Has Been Running Correctly Problems At Initial System StartupProblems Operating Add-In Boards Problems Running New Application SoftwareProblems Operating Pcmcia Cards What happens What to do Problems and SuggestionsOver Temperature Error and press enter Error Message / Beeps Explanation Error and Information MessagesPost Error Message ExplanationMessage Explanation PCI Configuration Status and Error MessagesResetting the System Appendix D Touch Screen optional Cmos ConfigurationFor Service For Further Information and Driver UpdatesAppendix E Technical Support Canada