Planar C3012T, C3013T user manual Replacing the Battery, Flash memory. See Chapter Five Bios Setup

Page 21

Replacing the Battery

Battery

(Rayovac BR2335 or equivalent)

Figure 12

Battery: Rayovac BR2335 or equivalent.

1.Remove the back housing as above.

2.Gently pulling up on the battery bracket, remove the old battery.

3.Slide in a new battery.

4.Upon startup, the system defaults will load. Enter Setup and go to the Exit menu to restore the CMOS settings saved in your flash memory. See Chapter Five: BIOS Setup for details.

Technical Note: Before removing the battery you must ensure the CMOS is backed up in

flash memory. See Chapter Five: BIOS Setup.

10Planar Clean Screen PC User’s Manual

Image 21
Contents User’s Manual Integrated Computer with LCD Color Display USER’S ManualIi Planar Clean Screen PC User’s Manual Commencement of Warranty Duration of WarrantyFederal Communications Commission FCC Requirements Limitation of Warranty Place of Repair or ReplacementInstallation Technical AssistanceTable of Contents Vi Planar Clean Screen PC User’s Manual Reference Guide ViiWhat’s in the box? Before You BeginWhat’s in this manual? What if I’m missing something?Clean Screen Mounts and Accessories Safety InstructionsConnections Bottom Front PanelSetup Chapter One The Installation ExpressChapter Two The Clean Screen PC Clean Screen FactsWelcome Connections Bottom Inside Back HousingChapter Two The Clean Screen PC Removing the Back Housing Chapter Three Hardware Installation and ReplacementDo not remove the T-Bar or standoffs Installing an ISA Adapter CardInstalling Memory To install a SO Dimm moduleTo remove an SO Dimm module Installing the new hard disk Replacing the Hard Disk DriveRemoving the existing hard disk Flash memory. See Chapter Five Bios Setup Replacing the BatteryReplacing the Fuses Mounting the Clean Screen Connecting the Keyboard Chapter Four System SetupConnecting Peripherals Floppy Drive ConnectorPower Cord Selection Power SupplyHeadphones or External Speakers Powering Up the Clean Screen PCPush-Button Volume Control Setup F2Driver Overview Front Panel ControlsChapter Five Bios Setup Entering the Bios Setup ProgramSetup Screens Main Menu Keyboard Features Sub-Menu Boot Sequence Sub-MenuMemory Cache Sub-Menu Memory Shadow Sub-MenuBoot Delay Boot Sequence Sub-Menu under Main MenuBoot Sequence Setup PromptSummary Screen Floppy CheckAdvanced Menu Bios Extension Offset in FBD Bios ExtensionsBios Extension Size Destination AddressIntegrated Peripherals Sub-Menu LPT ModeLPT Port Diskette ControllerTouch Panel Base Address Touch Panel IRQLocal Bus IDE Adapter Power Savings Power MenuStandby Timeout Suspend TimeoutStandby Timer Reset Events Fixed Disk TimeoutKeyboard Standby Break EventsStandby Wakeup Events Exit Menu Restore Condition Clear Over Temperature ErrorAppendix C Maintenance Tips Chapter Six Care and CleaningCleaning Tips Approved cleaning solutions includeAppendix a Product Specifications External Serial Ports Thermostatic Switch/Temperature SensorPrinter Port Floppy Disk Drive PortEnvironmental Specifications North America EuropeanDescription Pin Memory Map Appendix B Programming InterfaceAssigned and Available IRQs Range CPU address Region CachedDMAs Address ListAddress Device Appendix C Troubleshooting Troubleshooting ProcedureAnti-Virus Alert Causes Boot FailuresProblems After the System Has Been Running Correctly Problems At Initial System StartupProblems Operating Add-In Boards Problems Running New Application SoftwareProblems Operating Pcmcia Cards What happens What to do Problems and SuggestionsOver Temperature Error and press enter Error Message / Beeps Explanation Error and Information MessagesPost Error Message ExplanationMessage Explanation PCI Configuration Status and Error MessagesResetting the System Appendix D Touch Screen optional Cmos ConfigurationFor Service For Further Information and Driver UpdatesAppendix E Technical Support Canada