Planar C3013T, C3012T Installing an ISA Adapter Card, Do not remove the T-Bar or standoffs

Page 18

Installing an ISA Adapter Card

Figure 9

Do not remove the T-Bar or standoffs.

1.Remove the back housing as above.

2.Remove the blank metal spacer from the ISA panel slot using the T10 torx driver.

3.Locate the ISA connection beneath the T-Bar.

4.Turn the 1⁄2-card size ISA board upside down as you orient it toward the connection and the ISA panel slot.

5.Slide the card under the T-Bar, into the ISA connector and the ISA panel slot.

6.Tighten the torx screw on the ISA panel slot.

Chapter Three: Hardware Installation and Replacement 7

Image 18

Contents User’s Manual USER’S Manual Integrated Computer with LCD Color DisplayIi Planar Clean Screen PC User’s Manual Commencement of Warranty Duration of WarrantyFederal Communications Commission FCC Requirements Installation Place of Repair or ReplacementLimitation of Warranty Technical AssistanceTable of Contents Vi Planar Clean Screen PC User’s Manual Vii Reference GuideWhat’s in this manual? Before You BeginWhat’s in the box? What if I’m missing something?Safety Instructions Clean Screen Mounts and AccessoriesFront Panel Connections BottomChapter One The Installation Express SetupChapter Two The Clean Screen PC Clean Screen FactsWelcome Connections Bottom Back Housing InsideChapter Two The Clean Screen PC Chapter Three Hardware Installation and Replacement Removing the Back HousingInstalling an ISA Adapter Card Do not remove the T-Bar or standoffsInstalling Memory To install a SO Dimm moduleTo remove an SO Dimm module Installing the new hard disk Replacing the Hard Disk DriveRemoving the existing hard disk Replacing the Battery Flash memory. See Chapter Five Bios SetupReplacing the Fuses Mounting the Clean Screen Connecting Peripherals Chapter Four System SetupConnecting the Keyboard Floppy Drive ConnectorHeadphones or External Speakers Power SupplyPower Cord Selection Powering Up the Clean Screen PCDriver Overview Setup F2Push-Button Volume Control Front Panel ControlsChapter Five Bios Setup Entering the Bios Setup ProgramSetup Screens Main Menu Memory Cache Sub-Menu Boot Sequence Sub-MenuKeyboard Features Sub-Menu Memory Shadow Sub-MenuBoot Sequence Boot Sequence Sub-Menu under Main MenuBoot Delay Setup PromptFloppy Check Summary ScreenAdvanced Menu Bios Extension Size Bios ExtensionsBios Extension Offset in FBD Destination AddressLPT Port LPT ModeIntegrated Peripherals Sub-Menu Diskette ControllerTouch Panel Base Address Touch Panel IRQLocal Bus IDE Adapter Standby Timeout Power MenuPower Savings Suspend TimeoutKeyboard Fixed Disk TimeoutStandby Timer Reset Events Standby Break EventsStandby Wakeup Events Exit Menu Restore Condition Clear Over Temperature ErrorAppendix C Cleaning Tips Chapter Six Care and CleaningMaintenance Tips Approved cleaning solutions includeAppendix a Product Specifications Printer Port Thermostatic Switch/Temperature SensorExternal Serial Ports Floppy Disk Drive PortEnvironmental Specifications North America EuropeanDescription Pin Assigned and Available IRQs Appendix B Programming InterfaceMemory Map Range CPU address Region CachedDMAs Address ListAddress Device Appendix C Troubleshooting Troubleshooting ProcedureAnti-Virus Alert Boot Failures CausesProblems At Initial System Startup Problems After the System Has Been Running CorrectlyProblems Running New Application Software Problems Operating Add-In BoardsProblems Operating Pcmcia Cards Problems and Suggestions What happens What to doOver Temperature Error and press enter Error and Information Messages Error Message / Beeps ExplanationError Message Explanation PostPCI Configuration Status and Error Messages Message ExplanationResetting the System Cmos Configuration Appendix D Touch Screen optionalFor Service For Further Information and Driver UpdatesAppendix E Technical Support Canada