JVC G1000S Installing Batteries, Open the back cover, Install the batteries, Close the back cover

Controls and Features (Cont.)

Installing Batteries

Install batteries in the remote control. If the remote control has started to work erratically, replace the batteries.

1 Open the back cover.

While pushing on the back cover, slide it in the direction of the arrow.

2 Install the batteries.

Place the two batteries (AAA/R03-size) supplied in the remote control as illustrated below.

Precautions for using batteries

If batteries are used incorrectly, they may crack or leak liquid. This could cause a fire, burn, malfunction, or staining or damaging the surrounding.

Beware of the following:

•Do not mix new and old batteries.

•Do not mix different types of batteries as they differ in characteristics.

•Place batteries so they match the polarities indicated:

(+) to (+) and (–) to (–).

•Be sure to put the minus (–) end in first to avoid short- circuiting.

•Use only designated batteries.

•Remove the batteries if not used for a prolonged period of time.

•When the batteries are exhausted, replace them immediately. Otherwise, liquid could leak, or malfunction could occur due to leaked liquids. If the leaked liquid contacts the skin, wipe it off with a cloth, otherwise the skin could become rough.

•Do not put batteries into fire or try to recharge them.

•Batteries run for six months to one year in normal use. But the batteries supplied are for confirming operation and may not run that long. When the remote control starts failing to work properly, replace the batteries with new ones.

3 Close the back cover.

Slide the back cover in the direction of the arrow until a click is heard.

14

G1000S 05-14EN 14 98.9.21, 9:47 AM