PART NAMES AND FUNCTIONS
Zero key
Use as part of numeric keys to enter copy quantity. Press during a continuous copy run to display the number of copies completed in the current run.
Press and hold during standby to display the total output count.
1st display |
| 2nd display |
|
|
|
|
|
|
|
|
|
|
|
|
Press and hold down the key. | 12,345 sheets output |
Note: 11" x 17" size copies are counted as two copies.
CLEAR key
Clears the copy quantity display or terminates a copy run.
START key and indicator
Copying is possible when the indicator is on. Press to start copying.
CLEAR ALL (
) key
Clears all selected settings and returns the copier to the initial settings.
PRESET RATIO selector keys and indicators
(p. 17)
Use to sequentially select preset reduction/enlargement copy ratios: 50%, 64%, 77%, 95%, 100%, 121%, 129%, 141%, 200%.
ORIGINAL SIZE ENTER key and indicators
(p. 16)
Use to input the original size for automatic copy ratio selection.
GETTING STARTED Part names and functions
TRAY SELECT key (p. 14)
Use to manually select a paper tray.
AUTO IMAGE key and indicator
Press for automatic copy ratio selection.
Paper feed location/misfeed location indica- tors (p. 30)
The selected paper feed location is shown by a lit indicator (
).
The general location of misfed paper is shown by a blinking red indicator (
).
DUAL PAGE COPY key and indicator (p. 24)
Use to make individual copies of two originals placed side by side on the original table.
Initial settings
The copier assumes the initial settings when it is first turned on, when the CLEAR ALL (
) key is pressed, and ap- proximately one minute* after the last copy is made in any mode.
●Copy ratio: 100%
●Exposure: Automatic
●Copy quantity: 0
●All special copier modes: Off
●Paper feed station: Previously selected paper tray
*This time (auto clear time) can be changed. See page 35,
USER PROGRAMS.
7