Sharp F0-50 F0-70 operation manual General problems, Transmittable Documents in Chapter

Page 95

General problems

Problem		Solution

Nothing appears in the	•	Make sure the power cord is properly plugged into
display.		a power outlet.
	• Connect another electrical appliance to the outlet to
		see if it has power.

The machine does not	•	If a beep sound is not made when you press the
respond when you press		keys, unplug the power cord and then plug it in
any of its keys.		again several seconds later.

Automatic document	•	Check the size and weight of the document (see
feeding does not work for		Transmittable Documents in Chapter 2).
transmission or copying.

Voice calls taken on an	•	The fax may interrupt during a voice call if the
extension phone are		reception mode is set to A.M. To prevent
interrupted by the fax.		interruption on a tone dial extension phone, press
		any three keys on the extension phone after
		answering. (Note: Do not enter the code to activate
		fax reception.)

No reception occurs when	•	Make sure you have not run out of paper.
polling is attempted.
	•	Make sure the transmitting machine is in automatic
		reception mode.
	•	If the transmitting machine has polling security,
		make sure that your fax number has been entered
		both in your machine and in the transmitting
		machine.

Bell Tinkle	•	The operation of this equipment on the same line
(New Zealand)		as the telephone or other equipment with audible
		warning devices or automatic ring detectors will
		give rise to bell tinkle or noise and may cause false
		tripping of the ring detector. Should such a problem
		occur, contact your authorised Sharp Service
		Centre for information.

94

Image 95

Contents FO-50 FO-70 Storing and Clearing Auto Dial Numbers Entering Your Name and Number Setting the Date and TimeQuick Reference Guide Receiving Faxes Sending FaxesDisplay IntroductionCompression scheme Important safety information Page Page Important Notice For New Zealand Users Table of Contents Answering Machine Connection Unpacking Checklist InstallationLook at the Operation Panel Start key RESOLUTION/RECEPTION Mode keySpeed Dial key Redial keyAbout condensation Points to keep in mind when setting upConnections Connecting the Handset For FO-50 Remove the packing paper Removing the packing paperMoving your fax and reconnecting Connecting the power cordPress these keys Connecting the telephone line cordExtension phone optional Attaching the original document supportLoading the Thermal Paper Installation1 FO-50 FO-70 Handling thermal paper Replacing the thermal paperFO-20PRw Thermal Paper 30 m roll Entering Your Name and Fax Number Press the # key twice Display will show Example Sharp = 77777 444 22 Date & Time SET Setting the Date and Time Enter the year four digits Press the Start key to start Clock Mode Setting the Reception ModeTEL/FAX mode Picking up the fax machine’s handsetResolution Setting the reception modeSpeaker Volume AdjustmentSilent ring fax detection system RingerLoading one page at a time Size and weightSending Documents Transmittable DocumentsOther restrictions Loading the Document Removing a document from the feeder Remove the document Contrast settings Adjusting the Resolution and ContrastResolution settings List, the contrast setting Dark will Appear Press the Resolution Reception Mode key one orDesired Sending a Fax by Normal DialingBeep Using the Redial keySpeed Dial key Sending a Fax by Automatic DiallingStoring fax and telephone numbers for Automatic Dialling Press the Start key Clearing auto-dial numbers Chain Dialling for area and access codesMaking changes Rapid Key Dialling Speed Dialling Direct Keypad Dialling Searching for an auto-dial number Automatic redialling Press a number from 1 to 4 to select Condition for printing Transaction ReportSENDER/ Receiver Explanation of headingsReceiving Documents Using TEL/FAX ModeUsing FAX Mode Changing the number of rings Answering with the fax’s handset Using TEL Reception ModeAnswering with an extension phone Changing the number for remote fax activation CommentsFax Signal Receive Making Copies Rapid Key Dialling Press Making Telephone CallsNormal Dialling Enter the full Redial Chain DiallingHold Answering Machine Connection Connecting an Answering MachineActivating the answering machine connection Changing the outgoing messageHow the connection operates Quiet Detect Time Optional A.M. Mode SettingsQuiet Detect TM Fax when Answering machine Fails Quiet Detect Start Time Special Functions Caller ID Requires Subscription to ServicePress 1 to turn on Caller ID, or 2 to Turn it off Display messages How Caller ID operatesViewing the Caller ID list Priority Call To delete calls from the Caller ID listBlocking voice calls Distinctive Ring Requires Subscription to Service Press 1 to turn on Distinctive Ring, or To turn it off Blocking Reception of Unwanted Faxes Return to to enter or clear Polling Requesting a Fax Transmission Requesting transmission Printing Lists Anti Junk Number List Telephone Number ListCleaning the scanning glass and rollers MaintenanceCleaning the housing Line error TroubleshootingProblems and Solutions Correct socket. See Connecting the handset Dialling and transmission problemsSee Distinctive Ringing in Chapter Reception and copying problemsAnswering machine connection Transmittable Documents in Chapter General problemsFor display messages related to Caller ID Messages and SignalsOUT of Paper Audible signalsClearing a jammed document Clearing Paper JamsClearing jammed paper FO-50 FO-70 100 Index101 Sharp Corporation of NEW Zealand Limited