Sharp PNV600, PN-V600 Connections, Multiple monitor connection, Connection with video cable

Connections

When the PN-ZB02 (optional) is attached

8 9 10 11 12 13 14 1617 1 2 3 4 5

156

Caution

	1.	PC/AV HDMI input terminal
	2.	PC D-sub input terminal
	3.	Audio input terminal
	4.	Audio output terminals
	5.	RS-232C output terminal
	6.	RS-232C input terminal
	7.	Control kit terminal
	8.	PC/AV DVI-D input terminal
18 19	9.	PC/AV DVI-D output terminal
	10.	LAN terminal
7	11.	External speaker terminals
	12.	Audio1 input terminals
	13.	Audio2 input terminals
20	14.	PC RGB input terminals
	15.	AV component input terminals
For power	16.	AV video input terminal
	17.	AV S-video input terminal
outlet	18.	AC input terminal
	19.	Main power switch
	20.	Power cord (Supplied)

ENGLISH

•Be sure to turn off the main power switch and disconnect the plug from the power outlet before connecting/disconnecting cables. Also, read the manual of the equipment to be connected.

•Be careful not to confuse the input terminal with the output terminal when connecting cables. Accidentally reversing cables connected to the input and output terminals may cause malfunctions and the other problems.

TIPS

•Set the audio input terminal used for each input mode in AUDIO SELECT on the OPTION menu. The factory settings are shown below.

Input mode	Audio input terminal (Factory setting)
PC D-SUB, PC DVI-D, PC RGB	Audio input terminal
AV DVI-D	Audio1 input terminal
AV component,	Audio2 input terminal
AV S-video, AV video
PC HDMI, AV HDMI	PC/AV HDMI input terminal

•When connecting the external speaker, attach the speaker cable core (included in the optional PN-ZB02).

•HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing

LLC.

Multiple monitor connection

[Example]

	Remote control sensor box
	(Supplied with the PN-ZR01 (optional))
Second monitor	First monitor
Secondary	Primary
(Expansion unit)	(Main unit)
ID No.: 2	ID No.: 1
Third monitor	Fourth monitor
Secondary	Secondary
(Expansion unit)	(Expansion unit)
ID No.: 3	ID No.: 4

*Always install the remote control sensor box on the primary monitor.

■ Connection with video cable

May vary depending on the system being used.

If using the PC/AV DVI-D terminal, up to 5 monitors can be connected in a daisy chain. (When the PN-ZB02 is attached)

First monitor Second monitor

PC/AV DVI-D	PC/AV DVI-D	PC/AV DVI-D
input terminal	output terminal	input terminal

Digital signal (DVI) cables

(commercially available)

To PC digital RGB output terminal

shows the signal flow

5 E