TANDBERG ENTRYPOINT ISDN/PRI Configuration ISDN/PRI Versions only, Outgoing Bearer capability

Page 30

ISDN/PRI Configuration (ISDN/PRI Versions only)

TANDBERG ENTRYPOINT USER GUIDE

PRI Interface Configuration. Indicates the lowest numbered E1/T1 B-channel the system is allowed to use for each PRI-line when selecting channels for outgoing calls. Not in use in this version.

Enable CRC-4. Used for most E1-PRI configurations. If your network equipment does not support this feature, switch off PRI CRC-4.

Fractional line operation: Low Channel. Indicates the lowest numbered E1/ T1 B-channel the system is allowed to use for each PRI- line when selecting channels for outgoing calls. Presently, this setting has no effect.

Save. When all settings are entered, click on Save to store the new settings.

Note that changing from E1 to T1 configuration requires a restart of the unit (click Restart to restart the unit).

PRI Protocol. Select between the following PRI protocols:

•NI (National ISDN)

•ATT (AT&T Custom)

•Euro (ETSI = Euro ISDN)

•Japan (Japan/Taiwan ISDN)

Outgoing Bearer capability

Within ISDN different bearer capabilities are used to signal the type of data (Voice, Data, H320, H.324M), which is used by telephony switches and other equipment to determine how to handle data or calls (compressing voice data neglect etc). The outgoing bearer capability sets the ISDN bearer capability for the outgoing telephone (voice only) and video telephone calls.

•H.324M: This ITU standardized capability is selected for outgoing calls by default.

•UDI: In some situations the switch does not accept calls which use the correct H.324M capability. This setting makes it possible to use the Entrypoint in these situations via selecting UDI.

•Prefix on National/International Numbers

•Specifies the prefix, which has to be added to National and International numbers, respectively.

•The signalling specifies whether the call is national or international. Since these prefixes are removed from inbound telephone numbers, the correct prefixes have to be added on call-backs.

These settings only apply if the Service providers network uses prefixes for national and international calls.

All incoming calls are accepted independent of their bearer capabilities, consequently audio calls are accepted as well.

Table of

 

Trademarks

&

Patents &

 

Safety/

To

Get You

 

Using the

Viewing the

 

Configuring

Maintenance

 

Services

 

Dial Plan

 

Contact

Contents

 

Copyright

 

Disclaimers

 

Environmental

Up

and Going

 

Entrypoint

System Status

the

Entrypoint

& Upgrade

 

 

Examples

 

Information

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

30

 

 

 

 

 

 

 

 

 

 

D 14050.04

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

10.2007

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Page 29 Page 31
Image 30
Page 29 Page 31
Contents Guide Maintenance and Upgrade Operator Safety / Environmental IssuesUsing the Entrypoint ServicesTrademarks and Copyright Copyright 2007, TandbergDisclaimer, License Agreements, and Patent Information PatentsDisclaimers Disclaimer License Agreements Patent Information Operator Safety / Environmental Issues SafetySafety Instructions Environmental Issues Tandberg Entrypoint To get You Up and Going Get YouGoing Unpacking and Installation Connecting the CablesEntrypoint Features at a Glance About the Entrypoint Features HighlightsEntrypoint Capacity Typical Scenarios Front and Rear Panels IndicatorDepending on the configuration ordered Entrypoint Start-upConfiguring via the RS 232 Configuring Your Entrypoint via the RS 232About Gateway Configuration Configuration via the Front PanelConfiguration via RS 232 Configuring the IP Address via the Front PanelConfiguring via the Front Panel Switching On the UnitUsing the Entrypoint User name is admin Accessing the EntrypointForgot the Password? Starting Up the EntrypointRemote Number. This is the inbound number An Overview of the Management Menu SystemOverview Window Management MenuService Call Details About Service Call DetailsWhen View Details Has Been Selected Did Direct Inward Dialling Call Setup via Default ServicesAbout Default Services Dial Extension IVR ExampleDialling from Umts Using Phone Book Example of IVR Using the Phone BookAbout TMS Corporate Directory Viewing the System Status ViewingISDN/PRI Status PRI Versions only About the Rear Panel LED OperationISDN/BRI Status BRI Versions only Registration Status Inactive Gatekeeper StatusAbout H.323 Status Registration Status Registered Registration Status RejectedServices IVRSystem Information System Resources Configuring the Entrypoint ConfiguringISDN/PRI Configuration ISDN/PRI Versions only Outgoing Bearer capabilityPrefix on National/International Numbers ISDN/BRI Configuration ISDN/BRI Versions only IP Configuration DNS InterfaceIP Address Assignment is Dhcp or Static Configuration Configuration paneAuthentication Mode is Off or Auto SIP Configuration SIP settingsSnmp Configuration Save. Press Save to activate new settingsSystem Maintenance and Upgrade MaintenanceUpgrade Maintenance General For dot-release upgrades a Release Key won’t be neededMaintenance Upgrading the System Upgrading the SystemAdd Option key Key. Shows Maintenance Option Keys, Password and RestartOption Keys Password Restart Press Add OptionServices Default Services About Default Services Service Configuration WindowConfiguration menu from the Service tab Dialplan Configuration ExampleUnder Arguments Argument Details for the Default did ServiceDid Argument Details Allow forwarding. After callArgument Details for a Default IVR Service IVR Argument DetailsShow Dtmf Information Screen. This is a Argument Details for a Default Menu Service Menu Service Argument DetailsTMS Corporate Directory Argument Details Show Dtmf Information Screen. Identical toDial Plan Examples Dial PlanExamples Example 1 Number-plan mapping Some Dial Plan ExamplesAbout the Examples Prefix See note belowDial Extension IVR Examples Dial Extension IVR Dial Plan ExamplesExample 6 3G to SIP IVR Secretary Service Forwarding and Use Remainder to On for aTMS Corporate Directory Contact Information Contact
Top Page Image Contents