Motorola P880 manual Using the All Ports Configuration Dialog Box, Burst Size

2

Table 10. Fast Ethernet (10/100) Port Parameters

Parameter	Definition
Rate Limit	Determines the limit of packets allowed in a
Burst Size	single burst. Accepted values are 1 to 2048. For
	Fast Ethernet ports, set this value lower than
	1024 (output buffer capacity). Lower this value
	if the port has overflow problems.
Port PACE	Determines if the port detects 3Com’s
Priority	proprietary PACE format as packets pass
	through the port. PACE allows a packet’s
	priority (higher priority packets move through
	the switch before lower priority packets) to be
	set at the adapter.

Using the All Ports Configuration Dialog Box

The All Ports Configuration dialog box allows you to apply the same parameter settings to all ports in a module using a single command.

To set all ports in a module:

1.In the System Configuration section of the Web Agent window, select Modules & Ports. The Module Information dialog box opens.

2.In the Ports column, click the number for the module you want to configure (for example, 10 for 100BASE-FX). The Port Configuration dialog box opens.

3.Click All Module Switch Ports Configuration. The All Ports Configuration dialog box opens.

4.Set port parameters as described beginning in “Configuring Physical Port Parameters on Gigabit Ports”, earlier in this chapter .

5.Click APPLY to save your changes, or CANCEL to restore previous settings.

2 - 16 Cajun P880 Routing Switch Installation Guide