Installing the Modules
*Note: All Cajun media modules are
1.Carefully remove each module from its box, leaving the module in its antistatic wrapping.
2.After taking appropriate antistatic precautions, as described in "Preventing Electrostatic Discharge”, earlier in the chapter, carefully remove the module from the antistatic wrap.
3.Open the Ejector Tabs until the stops make contact with the face plate (Figure 7).
Figure 7. Installing Modules
4.Insert the module into the chassis (Figure 7).
5.Push on the center of the module pushing it into the chassis. The ejectors will snap into place.
Cajun P880 Routing Switch Installation Guide | 1 - 13 |