Motorola P880 Hardware Requirements for Routing, Configuring a Static Route for the PPP Console

2

Configuring a Static Route for the PPP Console

7.In the Mask field, enter the network mask IP address (for example, 255.255.255.0).

8.Click APPLY to save your changes, or CANCEL to restore previous settings.

To configure a PPP Console static route:

1.Configure your console serial port as a PPP Console. Refer to "Connecting a Modem", earlier in this chapter.

2.From the IP Configuration section of the Web Agent window, click Static Routes. The IP Static Routes dialog box opens.

3.Click CREATE. The Add IP Static Routes dialog box opens. This allows you to define a static route for the PPP console.

4.In the Network Address field, enter the IP address to be associated with the PPP console port.

5.In the Mask field, enter the network mask IP address.

6.In the Next-Hop Address field, enter the IP address of the gateway associated with this static route.

7.Click APPLY to save your changes, or CANCEL to restore previous settings.

Hardware Requirements for Routing

To configure your switch as an IP/IPX or AppleTalk router, you must first configure your Cajun switch with the following hardware:

■P880 supervisor module (mandatory)

■Layer 3 media modules (optional) including:

—2-Port Gigabit Ethernet module

—10-Port 100-BASE-F module

—12-Port 10/100-BASE-T module

2 - 36 Cajun P880 Routing Switch Installation Guide