Programming
DEFINE_EVENT
DATA_EVENT[vdvAnterus]
{
ONLINE:
{
SEND_COMMAND
SEND_COMMAND vdvAnterus,'REINIT'
}
}
Port Mapping
This module uses a single virtual device:
Port Mapping
Virtual Device | Channels | Control | Feedback |
|
|
|
|
41001:1:0 – Main | All | All | All |
|
|
|
|
Channels
The channels supported by the COMM module are listed below. These channels are associated with the virtual device(s) and are independent of the channels associated with the touch panel device.
Virtual Device Channel Events
Channel | Description | |
|
| |
251 | ON: Device communicating (feedback only) | |
OFF: Device not communicating (feedback only) | ||
| ||
|
| |
252 | ON: Data initialized (feedback only) | |
OFF: Data not initialized (feedback only) | ||
| ||
|
|
NetLinx Send Commands
There are two sets of NetLinx Send Commands supported by the COMM module, one set of Control commands and one set of Feedback commands.
Refer to the documentation supplied with the Anterus Duet Module for a full listing and description of supported NetLinx commands, as well as Installer Tips, Naming Conventions, Programming Notes, etc.
AxLink Programming Overview
The Anterus solution will also work without the Duet module, and all web configuration may be done with Send Commands, Channels and Levels.
Send Commands
The Anterus solution supports the AxLink Send Commands commands listed below. Note command messages either do not have a response, or are responded to with a COMMAND - not a string.
Send Commands
RSSI Threshold | The RSSI Upper and Lower Thresholds will be sent from the Master to the |
| |
| Levels section on page 31. |
| • The level value is equivalent to the RSSI value with range 0 to 255. |
|
|
RSSI Sensitivity Range | The RSSI Upper and Lower Thresholds will be sent from the Master to the |
| |
| Levels section on page 31. |
| • The level value is equivalent to the RSSI value with range 0 to 255. |
|
|
28 | Anterus RFID Solution |