Paxar Monarch 415 manual Operating the Rewind, Starting

Page 11

3. Operating the Rewind

Starting

1.Turn the speed control knob (Figure 6) to SLOW.

2.Push the rewind power switch (Figure 7) ON.

NOTE: The rewind will start to turn. When the dancer roller is almost horizontal, the rewind will stop.

3.Start the printer.

4.Adjust the rewind speed to the speed of the printer.

NOTE: If you stop the printer, the rewind will stop. If the printer runs out of supplies, the rewind will keep running until you turn it off.

Speed Control

Knob

Figure 6

Power

Switch

Figure 7

7

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Operator’s Handbook Trademarks Table of Contents Monarch 415 Rewind Operator’s Handbook Setting Up Fuse Holder Power Switch Cord Rewinding on the Hub Connecting SuppliesMonarch 415 Rewind Operator’s Handbook Rewinding on a Paper Core Monarch 415 Rewind Operator’s Handbook Starting Operating the RewindStopping Changing Hubs Hub Spindles End Extension Shaft Knob Burster Option Setup and Operation Separator Bars Label Edge Slot Label Edge Slot First Separator Disk Core Lock Second Separator Disk Notch Third Core Core Lock Label Edge Second Separator Disk Slot Opening Collar Label Edges Separator Bars Supply Removal Monarch 415 Rewind Operator’s Handbook Specifications Specifications and SuppliesProblem Corrective Action TroubleshootingAppendix a Rewind Alignment Toll Free
Top Page Image Contents