Paxar Monarch 415 manual Stopping

Page 12

Monarch 415 Rewind Operator’s Handbook

Stopping

1.Stop the printer.

2.Push the rewind power switch OFF.

3.Pull the supply guide away from the hub.

4.Cut the supply at the supply exit of the printer (Figure 8).

5.Tape the end of the supply to the roll on the rewind.

6.Pull the supply guide away from hub.

7.Hold the hub flange and turn the hub counterclockwise until the roll is loose.

8.Slide the roll off the hub.

Supply

Strip

Figure 8

8

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Operator’s Handbook Trademarks Table of Contents Monarch 415 Rewind Operator’s Handbook Setting Up Fuse Holder Power Switch Cord Connecting Supplies Rewinding on the HubMonarch 415 Rewind Operator’s Handbook Rewinding on a Paper Core Monarch 415 Rewind Operator’s Handbook Operating the Rewind StartingStopping Changing Hubs Hub Spindles End Extension Shaft Knob Burster Option Setup and Operation Separator Bars Label Edge Slot Label Edge Slot First Separator Disk Core Lock Second Separator Disk Notch Third Core Core Lock Label Edge Second Separator Disk Slot Opening Collar Label Edges Separator Bars Supply Removal Monarch 415 Rewind Operator’s Handbook Specifications and Supplies SpecificationsTroubleshooting Problem Corrective ActionAppendix a Rewind Alignment Toll Free
Top Page Image Contents